Why the default route using port2 is not displayed in the output of the second command?

Examine the following partial outputs from two routing debug commands; then answer the question below:

Why the default route using port2 is not displayed in the output of the second command?
A . It has a lower priority than the default route using port1.
B . It has a higher priority than the default route using port1.
C . It has a higher distance than the default route using port1.
D . It is disabled in the FortiGate configuration.

View Answer

Answer: C

Explanation:

http://kb.fortinet.com/kb/viewContent.do?externalId=FD32103