Which two parameters must you set in the BGP configuration?

Refer to the exhibit, which contains a partial BGP combination.

You want to configure a loopback as the OGP source.

Which two parameters must you set in the BGP configuration? (Choose two)
A . ebgp-enforce-multihop
B . recursive-next-hop
C . ibgp-enfoce-multihop
Questions and Answers PDF 3/41
D . update-source

View Answer

Answer: A, D

Explanation:

To configure a loopback as the BGP source, you need to set the “ebgp-enforce-multihop” and “update-source” parameters in the BGP configuration. The “ebgp-enforce-multihop” allows EBGP connections to neighbor routers that are not directly connected, while “update-source” specifies the IP address that should be used for the BGP session1.

Reference := BGP on loopback, Loopback interface, Technical Tip: Configuring EBGP Multihop Load-Balancing, Technical Tip: BGP routes are not installed in routing table with loopback as update source