Which set of steps configures the bridge domain that satisfies the requirements?

A bridge domain for an EPC called “Web Servers” must be created in the Cisco APIC.

The configuration must meet these requirements:

✑ Only traffic to known Mac addresses must be allowed to reduce noice.

✑ The multicast traffic must be limited to the ports that are participating in multicast routing.

✑ The endpoints within the bridge domain must be kept in the endpoint table for 20 minultes without any updates.

Which set of steps configures the bridge domain that satisfies the requirements?
A . Select the ARP Flooding checkbox.
Create an Endpoint Retention Policy with a Remote Endpoint Aging Interval of 20 minutes. Set L3 Unknown Multicast Flooding to Optimized Flooding
B. Set L2 Unknown Unicast to Hardware Proxy.
Configure L3 Unknown Multicast Flooding to Optimized Flood.
Create an Endpoint Retention Policy with a Local Endpoint Aging interval of 1200 seconds.
C. Switch L2 Unknown Unicast to Flood.
Select the default Endpoint Retention Policy and set the Local Endpoint Aging to 20 minutes.
Set Multicast Destination Flooding to Flood in Encapsulation.
D. Multicast Destination Flooding should be set to Flood in BD.
Set L3 Unknown Multicast Flooding to Flood.
Select the default Endpoint Retention Policy with a Local Endpoint Aging Interval of 1200 seconds.

View Answer

Answer: B