Which NetApp ONTAP command will show the status of this test?

An administrator has a NetApp AFF cluster with two SVMs serving LUNs. SnapMirror active sync is configured, and a disaster recovery test is planned over the weekend.

Which NetApp ONTAP command will show the status of this test?
A . snapmirror failover show
B . network interface failover-groups show
C . storage failover hwassist show
D . snapnirror config-replication status show

View Answer

Answer: A

Explanation:

To check the status of a SnapMirror active sync disaster recovery test on a NetApp ONTAP cluster, you would use the command snapmirror failover show. This command provides the necessary details about the failover status, helping administrators verify if the disaster recovery test is proceeding as expected. It displays the status of the failover groups and their readiness, which is essential for confirming the effectiveness of the disaster recovery setup.

For more detailed information on SnapMirror commands and their usage, refer to:

NetApp Documentation – SnapMirror Commands (NetApp Community) (NetApp Community).