Which interfaces should be connected to Orchestrator 1 for downlinks’ intra-orchestrator redundancy when using two Orchestrators?

There are two 10Gbps dual-port NICs and one 40Gbps NIC installed on a 23800 Appliance in slots 1, 2 and 3 accordingly.

Which interfaces should be connected to Orchestrator 1 for downlinks’ intra-orchestrator redundancy when using two Orchestrators?
A . Port 1 in Slot 2 and Port 2 in Slot 1
B . This configuration is not supported
C . Any pair of available ports
D . Port 1 in Slot 1 and Port 2 in Slot 1

View Answer

Answer: D

Explanation:

This configuration likely provides balanced and redundant connectivity for orchestrator redundancy. Reference

• Check Point Certified Maestro Expert (CCME) Courseware, Module 3: Dual

Orchestrator Environment, Lesson 3.1: Introduction to Dual Orchestrator Environment, page 3-7

• Check Point R81 Maestro Administration Guide, Chapter 3: Working with Security Group Modules, Section: Downlinks, page 3-8

• Check Point 23800 Appliance Datasheet – Check Point Software, page 2