Which configuration steps are needed?

A storage administrator wants to add as asynchronous replication session to a pair of Unity systems with an existing synchronous replication session that is operating correctly.

Which configuration steps are needed?
A . Create Replication interfaces on both systems.
Modify the Replication Connection Mode.
Run a Replication Connection Verify and Update operation.
B . Create Replication Interfaces on the source system.
Modify the Mode for Replication Connection.
Perform a manual Sync operation on the Asynchronous session.
C . Create Replication Interfaces on destination system.
Establish FC connectivity using the Synchronous FC Ports of each system.
Perform a manual Sync operation on the Asynchronous session.
D . Create Replication Interfaces on both systems.
Establish FC connectivity using the Synchronous FC Ports of each system.
Run a Verify and Update operation for the Replication Connection

View Answer

Answer: A

Explanation:

To fully configure asynchronous replication between systems, you must do each of following:

– Configure connectivity for the replication interfaces used by asynchronous replication

– Configure the replication connection between systems

– Configure replication sessions between systems

Note: To fully configure synchronous replication, you must complete each of following:

– Configure connectivity for the synchronous replication interfaces

– Create the synchronous replication management ports

– Configure the replication connection between systems

– Configure replication sessions between systems