Refer to the exhibit.
An engineer configures FCIP on a Cisco MDS 9000 Series switch.
What is the result of implementing the configuration?
A . The switch attempts to make two TCP connections
B . Compression is performed by using hardware
C . Mode2 is enabled by default.
D . Compression is performed by using software.
Answer: D
Explanation:
The configuration shown in the exhibit indicates that FCIP (Fibre Channel over IP) is configured with ip-compression mode2 enabled on a Cisco MDS 9000 Series switch. This means compression is performed by using software (Option D), as mode2 refers to software-based compression in FCIP configurations. The other options are not correct based on the configuration. The switch does not attempt to make two TCP connections, as there is no tcp-connections command in the configuration. Compression is not performed by using hardware, as mode1 refers to hardware-based compression in FCIP configurations. Mode2 is not enabled by default, as the default mode for FCIP compression is none.
Reference: Cisco MDS 9000 Family NX-OS Interfaces Configuration Guide, Release 8.x – Configuring FCIP [Cisco MDS 9000 NX-OS and SAN-OS Software], Configuring FCIP, Configuring FCIP Compression
Cisco MDS 9000 Family NX-OS Interfaces Configuration Guide, Release 8.x – Configuring FCIP [Cisco MDS 9000 NX-OS and SAN-OS Software], Configuring FCIP, Configuring the Number of TCP Connections for an FCIP Interface
Latest 350-601 Dumps Valid Version with 138 Q&As
Latest And Valid Q&A | Instant Download | Once Fail, Full Refund