What is the recommended way to power up VxRail E, V, P, and S Series nodes?

What is the recommended way to power up VxRail E, V, P, and S Series nodes?
A . Ensure the System Health indicatorblinks amber for 10 minutes after power on
B . Use the power button on the rear panel to power on each node
C . Wait at least 30 seconds between powering up each node
D . Use the iDRAC interface to power on each node

View Answer

Answer: B

Explanation:

Alternately, you can configure a custom management VLAN to allow tagged management traffic after you power on each node,

but before your run VxRail initial configuration. Your Dell EMC service representative will take care of this during installation.

Rack and cable the VxRail Appliance. After the nodes are cabled, power on all three or four initial nodes

in your VxRail cluster

https://www.emc.com/collateral/guide/h15300-vxrail-network-guide.pdf