What is the proper next step to make the device ready for use in a blueprint?

You are adding a new switch to Juniper Apstra software. The Managed Devices page shows the "0 OS-Quarantined" status.

What is the proper next step to make the device ready for use in a blueprint?
A . Acknowledge the device.
B . Take the device out of maintenance mode.
C . Install the agent for the device.
D . Take the device out of drain state.

View Answer

Answer: A

Explanation:

When a new switch is added to Juniper Apstra software, it initially shows the “0 OS-Quarantined” status, which means that the device is not yet managed by Apstra and has not been assigned to any blueprint. The proper next step to make the device ready for use in a blueprint is to acknowledge the device, which is a manual action that confirms the device identity and ownership. Acknowledging the device changes its status to “OOS-Ready”, which means that the device is ready to be assigned to a blueprint and deployed12.

References:

– Managing Devices

– AOS Device Configuration Lifecycle