What does the frame-relay interface-dlci command configure?

What does the frame-relay interface-dlci command configure?
A . local DLCI on the subinterface
B . remote DLCI on the main interface
C . remote DCLI on the subinterface
D . local DLCI on the main interface

View Answer

Answer: A

Explanation:

Frame Relay for ICND Exam

http://www.ciscopress.com/articles/article.asp?p=100603&seqNum=3

To assign a data-link connection identifier (DLCI) to a specified Frame Relay subinterface on the router or access server, or to assign a specific permanent virtual circuit (PVC) to a DLCI, or to apply a virtual template configuration for a PPP session, use the frame-relay interface-dlci interface configuration command

Example 4-23 Example of frame-relay interface-dlci Command and the Output of show frame-relay map

R4(config)#interface s1/2.403 point-to-point

R4(config-subif)#frame-relay interface-dlci ?

<16-1007> Define a switched or locally terminated DLCI

R4(config-subif)#frame-relay interface-dlci 403 ?

cisco Use CISCO Encapsulation

ietf Use RFC1490/RFC2427 Encapsulation

ppp Use RFC1973 Encapsulation to support PPP over FR protocol Optional protocol information for remote end

<cr>

R4#show frame-relay map

Serial1/2.403 (up): point-to-point dlci, dlci 403(0xC9,0x3090), broadcast status defined, active

R4#