What command is used to verify the DLCI destination address in a Frame Relay static configuration?

What command is used to verify the DLCI destination address in a Frame Relay static configuration?
A . show frame-relay pvc
B . show frame-relay lmi
C . show frame-relay map
D . show frame relay end-to-end

View Answer

Answer: C

Explanation:

Cisco Frame Relay Configurations

http://www.ciscopress.com/articles/article.asp?p=170741&seqNum=9

show frame-relay map

The show frame-relay map privileged EXEC mode command shows the contents of the next hop protocol address to DLCI mapping table on the router. The table contains both dynamic mapped and static mapped entries. The below example shows a sample output of the show frame-relay map command.

Router#show frame-relay map

Serial1/2 (up): ip 172.16.1.4 dlci 401(0x191,0x6410), dynamic,

broadcast, status defined, active

Serial1/2 (up): ip 172.16.1.5 dlci 501(0x1F5,0x7C50), dynamic,

broadcast, status defined, active

Serial1/2 (up): ip 172.16.1.2 dlci 301(0x12D,0x48D0), dynamic,

broadcast, status defined, active