To fully enable Dynamic Dispatcher on a Security Gateway:

To fully enable Dynamic Dispatcher on a Security Gateway:
A . run fw ctl multik set_mode 9 in Expert mode and then Reboot.
B . Using cpconfig, update the Dynamic Dispatcher value to “full” under the CoreXL menu.
C . Edit/proc/interrupts to include multik set_mode 1 at the bottom of the file, save, and reboot.
D . run fw multik set_mode 1 in Expert mode and then reboot.

View Answer

Answer: A

Explanation:

To fully enable Dynamic Dispatcher on a Security Gateway, you need to run the following command in Expert mode then reboot:

This command sets the multi-core mode to 9, which means that Dynamic Dispatcher is enabled without Firewall Priority Queues. Dynamic Dispatcher is a feature that optimizes the performance of Security Gateways with multiple CPU cores by dynamically allocating traffic to different cores based on their load and priority. Dynamic Dispatcher can improve the throughput and scalability of the Security Gateway, especially for traffic that is not accelerated by SecureXL. The other commands are not valid or do not enable Dynamic Dispatcher.

Reference: R81 Performance Tuning Administration Guide