- All Exams Instant Download
Which statements are true regarding the output in the exhibit?
Examine the output of the ‘get router info bgp summary’ command shown in the exhibit; then answer the question below. Which statements are true regarding the output in the exhibit? (Choose two.)A . BGP state of the peer 10.125.0.60 is Established. B. BGP peer 10.200.3.1 has never been down since...
Why isn’t there any output?
Examine the IPsec configuration shown in the exhibit; then answer the question below. An administrator wants to monitor the VPN by enabling the IKE real time debug using these commands: diagnose vpn ike log-filter src-addr4 10.0.10.1 diagnose debug application ike -1 diagnose debug enable The VPN is currently up, there...
Which real time debug should an administrator enable to troubleshoot RADIUS authentication problems?
Which real time debug should an administrator enable to troubleshoot RADIUS authentication problems?A . Diagnose debug application radius -1. B. Diagnose debug application fnbamd -1. C. Diagnose authd console Clog enable. D. Diagnose radius console Clog enable.View AnswerAnswer: B Explanation: https://kb.fortinet.com/kb/documentLink.do?externalID=FD32838
Which of the following statements about the exhibit are true?
View the exhibit, which contains the output of a BGP debug command, and then answer the question below. Which of the following statements about the exhibit are true? (Choose two.)A . For the peer 10.125.0.60, the BGP state of is Established. B. The local BGP peer has received a total...
If the administrator knows that there is no NAT device located between both FortiGates, what command should the administrator execute?
An administrator wants to capture ESP traffic between two FortiGates using the built-in sniffer. If the administrator knows that there is no NAT device located between both FortiGates, what command should the administrator execute?A . diagnose sniffer packet any ‘udp port 500’ B. diagnose sniffer packet any ‘udp port 4500’...
Under normal operation, how many OSPF full adjacencies are formed to each of the other two units?
Four FortiGate devices configured for OSPF connected to the same broadcast domain. The first unit is elected as the designated router. The second unit is elected as the backup designated router. Under normal operation, how many OSPF full adjacencies are formed to each of the other two units?A . 1...
What must the administrator change to fix the issue?
Refer to the exhibit, which shows a FortiGate configuration. An administrator is troubleshooting a web filter issue on FortiGate. The administrator has configured a web filter profile and applied it to a policy; however, the web filter is not inspecting any traffic that is passing through the policy. What must...
Assuming all the appropriate firewall policies are configured, which two pings will FortiGate route?
Refer to the exhibit, which shows a partial routing table. Assuming all the appropriate firewall policies are configured, which two pings will FortiGate route? (Choose two.)A . Source IP address: 10.1.0.10. Destination IP address: 10.64.1.52 B. Source IPaddress: 10.72.3.52. Destination IP address: 10.1.0.254 C. Source IPaddress: 10.10.4.24, Destination IPaddress: 10.72.3.20...
What does the log mean?
Examine the following traffic log; then answer the question below. date-20xx-02-01 time=19:52:01 devname=master device_id="xxxxxxx" log_id=0100020007 type=event subtype=system pri critical vd=root service=kemel status=failure msg="NAT port is exhausted." What does the log mean?A . There is not enough available memory in the system to create a new entry in the NAT port...
What events are recorded in the crashlogs of a FortiGate device? (Choose two.)
What events are recorded in the crashlogs of a FortiGate device? (Choose two.)A . A process crash. B. Configuration changes. C. Changes in the status of any of the FortiGuard licenses. D. System entering to and leaving from the proxy conserve mode.View AnswerAnswer: A,D Explanation: diagnose debug crashlog read 275:...
