What should the administrator check to fix the problem?

A FortiGate is configured as an explicit web proxy. Clients using this web proxy are reposting DNS errors when accessing any website. The administrator executes the following debug commands and observes that the n-dns-timeout counter is increasing: What should the administrator check to fix the problem?A . The connectivity between...

May 28, 2021 No Comments READ MORE +

Which statement is true regarding the session in the exhibit?

Examine the output of the ‘diagnose sys session list expectation’ command shown in the exhibit; than answer the question below. Which statement is true regarding the session in the exhibit?A . It was created by the FortiGate kernel to allow push updates from FotiGuard.B . It is for management traffic...

May 27, 2021 No Comments READ MORE +

How does FortiManager handle FortiGuard requests from FortiGate devices, when it is configured as a local FDS?

How does FortiManager handle FortiGuard requests from FortiGate devices, when it is configured as a local FDS?A . FortiManager can download and maintain local copies of FortiGuard databases.B . FortiManager supports only FortiGuard push to managed devices.C . FortiManager will respond to update requests only if they originate from a...

May 26, 2021 No Comments READ MORE +

Which two conditions must be met for a statistic route to be active in the routing table? (Choose two.)

Which two conditions must be met for a statistic route to be active in the routing table? (Choose two.)A . The link health monitor (if configured) is up.B . There is no other route, to the same destination, with a higherdistance.C . The outgoing interface is up.D . The next-hop...

May 26, 2021 No Comments READ MORE +

What does the log mean?

Examine the following traffic log; then answer the question below. date-20xx-02-01 time=19:52:01 devname=master device_id="xxxxxxx" log_id=0100020007 type=event subtype=system pri critical vd=root service=kemel status=failure msg="NAT port is exhausted." What does the log mean?A . There is not enough available memory in the system to create a new entry inthe NAT port table.B...

May 26, 2021 No Comments READ MORE +

Based on the error displayed by the debug flow, which are valid reasons for this problem?

0.1.254. The administrator runs the debug flow while attempting the connection using HTTP. The output of the debug flow is shown in the exhibit: Based on the error displayed by the debug flow, which are valid reasons for this problem? (Choose two.)A . HTTP administrative access is disabled in the...

May 25, 2021 No Comments READ MORE +

What events are recorded in the crashlogs of a FortiGate device? (Choose two.)

What events are recorded in the crashlogs of a FortiGate device? (Choose two.)A . A process crash.B . Configuration changes.C . Changes in the status of any of the FortiGuard licenses.D . System entering to and leaving from the proxy conserve mode.View AnswerAnswer: A,D Explanation: diagnose debug crashlog read 275:...

May 25, 2021 No Comments READ MORE +

Which of the following statements about the exhibit are true?

View the exhibit, which contains the output of a BGP debug command, and then answer the question below. Which of the following statements about the exhibit are true? (Choose two.)A . The local router's BGP state is Established with the 10.125.0.60 peer.B . Since the counters were last reset; the...

May 24, 2021 No Comments READ MORE +

Which of the following statements is true regarding this configuration?

View the global IPS configuration, and then answer the question below. Which of the following statements is true regarding this configuration?A . IPS will scan every byte in every session.B . FortiGate will spawn IPS engine instances based on the system load.C . New packets will be passed through without...

May 24, 2021 No Comments READ MORE +

What HA setting must be changed in one of the HA clusters to fix the problem?

Two independent FortiGate HA clusters are connected to the same broadcast domain. The administrator has reported that both clusters are using the same HA virtual MAC address. This creates a duplicated MAC address problem in the network. What HA setting must be changed in one of the HA clusters to...

May 23, 2021 No Comments READ MORE +