Which one of the following processes is involved in updating IPS from FortiGuard?

Which one of the following processes is involved in updating IPS from FortiGuard?A . FortiGate IPS update requests are sent using UDP port 443.B . Protocol decoder update requests are sent to service.fortiguard.net.C . IPS signature update requests are sent to update.fortiguard.net.D . IPS engine updates can only be obtained...

July 22, 2020 No Comments READ MORE +

Which of the following statements correctly describes FortiGates route lookup behavior when searching for a suitable gateway? (Choose two)

Which of the following statements correctly describes FortiGates route lookup behavior when searching for a suitable gateway? (Choose two)A . Lookup is done on the first packet from the session originatorB . Lookup is done on the last packet sent from the responderC . Lookup is done on every packet,...

July 22, 2020 No Comments READ MORE +

Which of the following statements about converse mode are true? (Choose two.)

Which of the following statements about converse mode are true? (Choose two.)A . FortiGate stops sending files to FortiSandbox for inspection.B . FortiGate stops doing RPF checks over incoming packets.C . Administrators cannot change the configuration.D . Administrators can access the FortiGate only through the console port.View AnswerAnswer: A C

July 22, 2020 No Comments READ MORE +

Which security profile’s configuration does not change when you enable policy-based inspection?

NGFW mode allows policy-based configuration for most inspection rules. Which security profile’s configuration does not change when you enable policy-based inspection?A . Web filteringB . AntivirusC . Web proxyD . Application controlView AnswerAnswer: B

July 22, 2020 No Comments READ MORE +

Which statements about DNS filter profiles are true? (Choose two.)

Which statements about DNS filter profiles are true? (Choose two.)A . They can inspect HTTP traffic.B . They can redirect blocked requests to a specific portal.C . They can block DNS requests to known botnet command and control servers.D . They must be applied in firewall policies with SSL inspection...

July 22, 2020 No Comments READ MORE +

Why did the FortiGate drop the packet?

Examine this output from a debug flow: Why did the FortiGate drop the packet?A . The next-hop IP address is unreachable.B . It failed the RPF check.C . It matched an explicitly configured firewall policy with the action DENE . It matched the default implicit firewall policy.View AnswerAnswer: D

July 22, 2020 No Comments READ MORE +

If traffic matches a DLP filter with the action set to Quarantine IP Address, what action does FortiGate take?

If traffic matches a DLP filter with the action set to Quarantine IP Address, what action does FortiGate take?A . It notifies the administrator by sending an email.B . It provides a DLP block replacement page with a link to download the file.C . It blocks all future traffic for...

July 22, 2020 No Comments READ MORE +

Which of the following static routes will satisfy this requirement on FGT1?

Examine the network diagram shown in the exhibit, and then answer the following question: A firewall administrator must configure equal cost multipath (ECMP) routing on FGT1 to ensure both port1 and port3 links are used at the same time for all traffic destined for 172.20.2.0/24. Which of the following static...

July 22, 2020 No Comments READ MORE +

Which of the following statements are correct?

View the exhibit. Which of the following statements are correct? (Choose two.)A . This setup requires at least two firewall policies with the action set to IPsec.B . Dead peer detection must be disabled to support this type of IPsec setup.C . The TunnelB route is the primary route for...

July 22, 2020 No Comments READ MORE +

Which of the following static routes will satisfy this requirement on FGT1?

Examine the network diagram shown in the exhibit, and then answer the following question: A firewall administrator must configure equal cost multipath (ECMP) routing on FGT1 to ensure both port1 and port3 links are used at the same time for all traffic destined for 172.20.2.0/24. Which of the following static...

July 21, 2020 No Comments READ MORE +