- All Exams Instant Download
What does the acronym ACP mean?
What does the acronym ACP mean?A . Alternate Communication PathB . Available Communication PathC . Alternate Control PathD . Available Control PathView AnswerAnswer: C
What is the minimum number of cluster interconnect connections required in a 6-node cluster when using FAS8060 nodes?
What is the minimum number of cluster interconnect connections required in a 6-node cluster when using FAS8060 nodes?A . 6B . 12C . 3D . 0View AnswerAnswer: B
Which solution would provide the largest possible cluster?
You were dispatched to install a cluster made up of FAS8060 and FAS8080 controllers. There are three FAS8060 controllers and three FAS8080 controllers. Which solution would provide the largest possible cluster?A . a cluster made up of six nodesB . a cluster made up of five nodesC . a cluster...
What are two supported cluster interconnect switches for the FAS8040 nodes? (Choose two.)
What are two supported cluster interconnect switches for the FAS8040 nodes? (Choose two.)A . NetApp CN1610B . NetApp CN1601C . Cisco NX5596D . Cisco Catalyst 2960View AnswerAnswer: AC
In this scenario, which network is used for the traffic being relocated?
You have a 4-node FAS8060 cluster. You are using the vol move command to relocate a volume from an aggregate on node 1 to an aggregate on node 4. In this scenario, which network is used for the traffic being relocated?A . the HA interconnectB . the cluster interconnectC ....
Which action would you use to accomplish this task?
You just finished the installation of a new 4-node cluster and the customer asks you to move an already used Ethernet port to a new broadcast domain. Which action would you use to accomplish this task?A . Remove all LIFs on this port and create a new broadcast domain.B ....
In this situation, what are two valid procedures that will allow you to collect the Config Advisor output?
You have completed the installation of a 4-node cluster. The customer did not purchase management switches and will not allow your laptop on the network. In this situation, what are two valid procedures that will allow you to collect the Config Advisor output? (Choose two.)A . Connect four USB serial...
Starting with ONTAP 9.1, what is the maximum number of HA pairs that are supported when using a SAN cluster?
Starting with ONTAP 9.1, what is the maximum number of HA pairs that are supported when using a SAN cluster?A . 8B . 2C . 4D . 6View AnswerAnswer: C
What is the next step to complete the setup of the newly installed SAS shelves?
You have installed a new stack of SAS disk shelves, powered them on, and set the shelf IDs. What is the next step to complete the setup of the newly installed SAS shelves?A . You must power-cycle each disk shelf.B . You must finish the switch configurations.C . You must...
Which statement is true in this scenario?
You are asked to install a 6-node cluster of FAS8080 controllers. The installation has been completed and Config Advisor shows no warnings or errors. The customer can ping and access the controller. Which statement is true in this scenario?A . This installation has not been completed successfully until you have...
