Which step should the administrator use to initiate the project?

An organization is running a Nutanix Cluster based on AOS 5.10.x and VMware vSphere 6.7. Currently, the CVM network is segmented and Storage only nodes not present. A new security project based on NSX is coming. VMware Distributed Virtual Switches are required. The administrator needs to prepare the environment for...

October 29, 2021 No Comments READ MORE +

Where should this server be hosted?

An administrator is configuring software only. Data-at-Rest Encryption on their Nutanix cluster. They are planning to deploy a third-party key management server (KMS). Where should this server be hosted?A . As a single VM on the Nutanix clusterB . On hardware external to the Nutanix dusterC . As a clustered...

October 29, 2021 No Comments READ MORE +

Which component requires administrator attention?

An administrator needs to create and start five new VMs for a Data Analytics Project (OLAP). The VM Profile is as follows: • vCPU:4 • vRAM: 64 GB • vDisk: 1.5 TB Each of the four nodes of the Nutanix cluster has the following: • 24 vCPU. 20% overall usage...

October 29, 2021 No Comments READ MORE +

Which two menus should be used to check the current configuration?

A VDI environment based on AHV Cluster is not performing well. The current environment is using only one bridge (Bridge0). The administrator needs to verify if nodes are using all network cards associated to Bridge0. Which two menus should be used to check the current configuration? (Choose two.)A . Network...

October 28, 2021 No Comments READ MORE +

What is the cause for the connectivity failure to the FVM?

A consultant is onsite with a customer running Foundation VM (FVM) and discovers that there is no connectivity between the FVM and their laptop. The consultant verifies the following: * The consultant’s laptop and Nutanix nodes are plugged into a flat switch. * The laptop, switch and nodes are plugged...

October 28, 2021 No Comments READ MORE +

What is the consequence of running the cluster at 81% storage utilization?

A customer with a four-node RF2 cluster is adding application VMs to their system. After adding these VMs, the Prism dashboard shows 81% storage utilization. What is the consequence of running the cluster at 81% storage utilization?A . The customer has the ability to add more VMs up to the...

October 28, 2021 No Comments READ MORE +

What should the administrator do to resolve this issue efficiently?

Refer to the exhibit. After performing ESXi to AHV conversion on a cluster, the alerts shown in the exhibit display on Prism . What should the administrator do to resolve this issue efficiently?A . Remove the VMs. create a new Protection Domain, and add VMs to itB . Remove VMs...

October 27, 2021 No Comments READ MORE +

What is causing this alert?

Refer to the exhibit. An administrator notices a critical alert on the Metro Availability Protection Domain What is causing this alert?A . Metro Availability Protection domain is active on the remote site.B . VMware Site Recovery Manager is handling a failover eventC . Metro Availability did not fail over and...

October 27, 2021 No Comments READ MORE +

Which type of VM is being described?

A VM does not have enough resources for the demand, which leads to performance bottlenecks. The VM is exhibiting one or more of following baseline values, based on the past 30 days: • CPU usage > 90% (moderate), 95% (high) • CPU ready time > 5%, 10% • Memory usage...

October 27, 2021 No Comments READ MORE +

What is the recommended configuration change to improve throughput?

An administrator has a custom backup application that requires a 2TB disk and runs in Windows. Throughput is considerably lower than expected. The application was installed on a VM with the following configuration: • Four vCPUs with one core/vCPU • 4GB of Memory • One 50GB vDisk for the Windows...

October 27, 2021 No Comments READ MORE +