- All Exams Instant Download
Which two actions should you take to solve this problem?
Exhibit: Referring to the exhibit, the local BGP router is receiving IPv4 routes from the BGP neighbor, but it is not receiving L3 VPN routes from the BGP neighbor. Which two actions should you take to solve this problem? (Choose two.)A . Configure the family inet-vpn unicast statement on the...
You are creating an LDP-signaled Layer 2 circuit between two sites. Site1 and Site2 use different VLAN IDs to connect to your PE devices In this scenario, which encapsulation type must be used on the logical interfaces?
You are creating an LDP-signaled Layer 2 circuit between two sites. Site1 and Site2 use different VLAN IDs to connect to your PE devices In this scenario, which encapsulation type must be used on the logical interfaces?A . vlan-bridgeB . vlan-cccC . vlan-tccD . vlan-vplsView AnswerAnswer: C
Referring to the exhibit, which path would traffic passing through R1 take to get
Exhibit: Referring to the exhibit, which path would traffic passing through R1 take to get.A . R1 -> R2 -> R4 -> R6B . R1 -> R2 -> R3 -> R6C . R1 -> R3 -> R5 -> R6D . R1 -> R3 -> R4 -> R6View AnswerAnswer: C
Referring to the exhibit, which statement is true?
Exhibit. You are provisioning Layer 2 circuits between sites CE1. CE2. andCE3 Referring to the exhibit, which statement is true?A . Two VLANs must be configured from PE1 to CE1.B . A point-to-multipoint LSP must be created between sites.C . Site PE1 must have a point-to-multipoint link configured towards the...
Which three actions are needed to accomplish this task?
You want to allow the load balancing of traffic for an EBGP route from two different peers in the same AS. Which three actions are needed to accomplish this task? (Choose three.)A . A policy to load-balance traffic should be applied to the forwarding tableB . At least two interfaces...
In this scenario where would you configure loop prevention?
Exhibit. You have the LDP signaled VPLS topology as shown in the exhibit CE-B at Site-2 is multihomed to both PE-2 and PE-3 In this scenario where would you configure loop prevention?A . PE-2B . PE-3C . CE-BD . PE-1View AnswerAnswer: D
What information is stored in a VRF table for a BGP Layer 2 VPN? (Choose three.)
What information is stored in a VRF table for a BGP Layer 2 VPN? (Choose three.)A . Layer 2 encapsulationB . local site IDC . remote interface of local CE deviceD . logical interlace provisioned to local CE deviceE . label-switched pathView AnswerAnswer: ABD
In this scenario which two types of routing instances should be configured?
You are deploying a new EVPN service for your customers. You must build the service based on the following requirements -- both Layer 2 and Layer 3 functionality must be supported -- your customers must be able to support multiple VLANs in the same EVPN instance (EVI). In this scenario...
Which statement is correct in this scenario?
The link between CE1 and PE1 has a history of flapping To avoid the impact that flapping causes to the network you decide to use route damping Which statement is correct in this scenario?A . Dampened routes decay at a sliding rate known as half-lifeB . Routes become dampened when...
Referring to the exhibit, which statement is true?
Exhibit: Referring to the exhibit, which statement is true?A . The route is learned from only one neighbor.B . This is a multipath route.C . The route is learned from three different neighbors.D . This is a multihop route.View AnswerAnswer: B
