JN0-348 exam

You execute the operational-mode command show ospf neighbor and notice that one neighbor relationship remains in the exStart state. What causes this behavior?A . The authentication parameters do not match on each end of the link.B . The area IDs do not match on each end of the link.C ....

You just installed Switch-1 and Switch-2 in your network. Both switches are EX Series switches and are connected to each other using a Layer 2 switch port. Switch-1 must run STP, whereas Switch-2 must run RSTP. Given the scenario, which statement is true?A . The two switches run in dual-mode...

Which static route next-hop value indicated that the packet will be silently dropped?A . rejectB . resolveC . discardD . next-tableView AnswerAnswer: C

Which two statements about dynamic ARP inspection ( DAI) are true?A . You enable DAI on each port.B . You can set individual ports as trusted by adding the dhcp-trusted parameter on a given port.C . Trunk ports are untrusted by default.D . DAI depends on the entries found in...

0.0.0/8 prefix-length-range /8-/16;A . 25.0.0.0/8B . 26.0.0.0/8C . 23.0.0.0/8D . 24.0.0.0/8View AnswerAnswer: C

129.12.2 ge-0/0/2.0 ExStart 66.129.12.2 128 37A . There is a hello interval mismatch.B . There is an interface MTU mismatch.C . There is an authentication mismatch.D . There is an IP network mismatch.View AnswerAnswer: B

Which two statements are correct about how EX Series switches support STP and RSTP interoperability?A . A switch running only STP discards RSTP BPDUs.B . A switch running RSTP accepts STP BPDUs and responds using STP BPDUs.C . A switch running RSTP accepts STP BPDUs and responds using RSTP BPDUs.D...

As shown in the exhibit, Switch-3 receives a superior BPDU from Switch-2 over the ge-0/0/10.0 interface. Which two statements are correct?A . Switch-3's ge-0/0/10.0 port assumes the alternate role and blocking state.B . Switch-3's ge-0/0/10.0 port assumes the designated role and forwarding state.C . Switch-2's ge-0/0/10.0 port assumes the designated...

Which two statements are true regarding the default VLAN in EX Series switches?A . An administrator can change the VLAN ID of the default VLAC . The show interface-command shows an asterisk ( *) after the interface name if the interface is part of default VLAE . An interface that...

You execute the operational-mode command show ospf neighbor and notice that one neighbor relationship remains in the exStart state. What causes this behavior?A . The authentication parameters do not match on each end of the link.B . The area IDs do not match on each end of the link.C ....