- All Exams Instant Download
Which steps need to be implemented to allow ClearPass to perform a CoA and change the access for this wired device?
A network engineer recently identified that a wired device connected to a CX Switch is misbehaving on the network To address this issue, a new ClearPass policy has been put in place to prevent this device from connecting to the network again. Which steps need to be implemented to allow...
What is an OSPF transit network?
What is an OSPF transit network?A . a network that uses tunnels to connect two areas B. a special network that connects two different areas C. a network on which a router discovers at least one neighbor D. a network that connects to a different routing protocolView AnswerAnswer: B Explanation:...
In AOS 10. which session-based ACL below will only allow ping from any wired station to wireless clients but will not allow ping from wireless clients to wired stations"? The wired host ingress traffic arrives on a trusted port.
In AOS 10. which session-based ACL below will only allow ping from any wired station to wireless clients but will not allow ping from wireless clients to wired stations"? The wired host ingress traffic arrives on a trusted port.A . ip access-list session pingFromWired any user any permit B. ip...
What is the solution for this?
A customer is using stacked Aruba CX 6200 and CX 6300 switches for access and a VSX pair of Aruba CX 8325 as a collapsed core 802 1X is implemented for authentication. Due to the lack of cabling, some unmanaged switches are still in use Sometimes devices behind these switches...
Which method is used to onboard a new UXI in an existing environment with 802 1X authentication? (The sensor has no cellular connection)
Which method is used to onboard a new UXI in an existing environment with 802 1X authentication? (The sensor has no cellular connection)A . Use the UXI app on your smartphone and connect the UXI via Bluetooth B. Use the Aruba installer app on your smartphone to scan the barcode...
How is Multicast Transmission Optimization implemented in an HPE Aruba wireless network?
How is Multicast Transmission Optimization implemented in an HPE Aruba wireless network?A . "The optimal rate for sending multicast frames is based on the highest broadcast rate across all associated clients B. When this option is enabled the minimum default rate for multicast traffic is set to 12 Mbps for...
What is correct about access from the servers to the Core?
Two AOS-CX switches are configured with VSX at the the Access-Aggregation layer where servers attach to them An SVI interface is configured for VLAN 10 and serves as the default gateway for VLAN 10. The ISL link between the switches fails, but the keepalive interface functions. Active gateway has been...
You need to create a keepalive network between two Aruba CX 8325 switches for VSX configuration How should you establish the keepalive connection?
You need to create a keepalive network between two Aruba CX 8325 switches for VSX configuration How should you establish the keepalive connection?A . SVI, VLAN trunk allowed all on ISL in default VRF B. routed port in custom VRF C. loopback 0 and OSPF area 0 in default VRF...
What is true regarding 802.11k?
What is true regarding 802.11k?A . It extends radio measurements to define mechanisms for wireless network management of stations B. It reduces roaming delay by pre-authenticating clients with multiple target APs before a client roams to an AP C. It provides mechanisms for APs and clients to dynamically measure the...
What is an Aruba-recommended best practice for hardening that only applies to Aruba CX 6300 series switches with dedicated management ports?
What is an Aruba-recommended best practice for hardening that only applies to Aruba CX 6300 series switches with dedicated management ports?A . Implement a control plane ACL to limit access to approved IPs and/or subnets B. Manually enable Enhanced Security Mode from a console session. C. Disable all management services...
