Which technology minimizes flooding so the legacy application can work efficiently?
A customer is using a legacy application that communicates at layer-2. The customer would like to keep this application working across the campus which is connected via layer-3. The legacy devices are connected to Aruba CX 6300 switches throughout the campus. Which technology minimizes flooding so the legacy application can...
Which action must the administrator perform to address this situation?
A company deployed Dynamic Segmentation with their CX switches and Gateways After performing a security audit on their network, they discovered that the tunnels built between the CX switch and the Aruba Gateway are not encrypted. The company is concerned that bad actors could try to insert spoofed messages on...
What is the correct configuration to ensure that APs will work properly?
A system engineer needs to preconfigure several Aruba CX 6300 switches that will be sent to a remote office An untrained local field technician will do the rollout of the switches and the mounting of several AP-515s and AP-575S. Cables running to theAPs are not labeled. The VLANs are already...
What is the benefit of VSX clustering with the new solution?
The customer needs a network hardware refresh to replace an aging Aruba 5406R core switch pair using spanning tree configuration with Aruba CX 8360-32YC switches. What is the benefit of VSX clustering with the new solution?A . stacked data-planeB . faster MSTP converge processingC . dual Aruba AP LAN port...
What is enabled by LLDP-MED? (Select two.)
What is enabled by LLDP-MED? (Select two.)A . Voice VLANs can be automatically configured for VoIP phonesB . APs can request power as needed from PoE-enabled switch portsC . iSCSl client devices can request to have flow control enabledD . GVRP VLAN information can be used to dynamically add VLANs...
In an ArubaOS 10 architecture using an AP and a gateway, what happens when a client attempts to join the network and the WLAN is configured with OWE?
In an ArubaOS 10 architecture using an AP and a gateway, what happens when a client attempts to join the network and the WLAN is configured with OWE?A . Authentication information is not exchangedB . The Gateway will not respond.C . No encryption is applied.D . RADIUS protocol is utilized.View...
What would be the calculated Equivalent Isotropic Radiated Power (EIRP) for APT?
You are doing tests in your lab and with the following equipment specifications * AP1 has a radio that generates a 10 dBm signal * AP2 has a radio that generates a 11 dBm signal * AP1 has an antenna with a gain of 9 dBi * AP2 has an...
What is an Aruba-recommended best practice for hardening that only applies to Aruba CX 6300 series switches with dedicated management ports?
What is an Aruba-recommended best practice for hardening that only applies to Aruba CX 6300 series switches with dedicated management ports?A . Implement a control plane ACL to limit access to approved IPs and/or subnetsB . Manually enable Enhanced Security Mode from a console session.C . Disable all management services...
What is true regarding 802.11k?
What is true regarding 802.11k?A . It extends radio measurements to define mechanisms for wireless network management of stationsB . It reduces roaming delay by pre-authenticating clients with multiple target APs before a client roams to an APC . It provides mechanisms for APs and clients to dynamically measure the...
Which steps need to be implemented to allow ClearPass to perform a CoA and change the access for this wired device?
A network engineer recently identified that a wired device connected to a CX Switch is misbehaving on the network To address this issue, a new ClearPass policy has been put in place to prevent this device from connecting to the network again. Which steps need to be implemented to allow...