What is the expected behavior if Switch-1 later fails to receive keepalive messages from Switch-2?
Refer to the exhibits. The network administrator enters the commands shown in Exhibit 2, and Switch-1 and Switch-2 exchange keepalive messages. What is the expected behavior if Switch-1 later fails to receive keepalive messages from Switch-2?A . Switch-1 disables interface 1 for 10 seconds, and then re-enables it. The same...
Which benefit does the PAPI enhanced security key provide?
An AOS-Switch implements tunneled node. Which benefit does the PAPI enhanced security key provide?A . It validates the signature for firmware pushed to the switch dynamically.B . It encrypts traffic sent and received by tunneled-node endpoints.C . It authenticates control traffic between the switch and its Mobility Controller.D . It...
How does the switch handle this traffic?
Refer to the exhibits. Exhibit 1. Exhibit 2. The VoIP phone connects, authenticates successfully, and is dynamically assigned to tagged VLAN 6. The endpoint connected to the phone does not authenticate but starts to send untagged traffic. How does the switch handle this traffic?A . It forwards the traffic in...
Exhibit 1 shows a portion of the BGP routing table when the BGP solution was first deployed. Exhibit 2 shows the same portion at the current time. What can explain the current state?
Refer to the exhibits. Exhibit 1 Exhibit 2 Exhibit 1 shows a portion of the BGP routing table when the BGP solution was first deployed. Exhibit 2 shows the same portion at the current time. What can explain the current state?A . Due to changes in the private network, Switch-1...
Which technology should the administrator implement on the connected switch interfaces?
Two AOS-Switches are directly interconnected. The network administrator wants to prevent broadcast storms and other Layer 2 issues that could occur if there is physical damage to a cable. Which technology should the administrator implement on the connected switch interfaces?A . MAC LockdownB . Bidirectional Forwarding Detection (BFD)C . Spanning...
Switch-1 runs BGP. What should the network administrator do to permit Switch-1 to establish a neighbor relationship with Router-1?
Refer to the exhibit. Switch-1 runs BGP. What should the network administrator do to permit Switch-1 to establish a neighbor relationship with Router-1?A . Configure 192.168.1.2 as a neighbor manually within the BGP context.B . Specify 192.168.1.0/30 with the network command in the BGP context.C . Enable BGP on VLAN...
How can the administrator check if the network infrastructure prioritizes traffic from Device 1 and Device 2?
Refer to the exhibit. A network administrator sets up prioritization for an application that runs between Device 1 and Device 2. However, the QoS for the application is not what the administrator expects. How can the administrator check if the network infrastructure prioritizes traffic from Device 1 and Device 2?A...
What should a network administrator do to support a faster failover in a similar situation?
Refer to the exhibit. The routing switches shown in the exhibit run OSPF on the links between each other. The commander in the Switch-1 VSF fabric goes down. Traffic is disrupted for several seconds. What should a network administrator do to support a faster failover in a similar situation?A ....
A company requires distribution layer switches that can provide Layer 2 and Layer 3 redundancy. The exhibit shows the proposal for these switches. Which change to the proposal will help meet the company’s requirements?
Refer to the exhibit. A company requires distribution layer switches that can provide Layer 2 and Layer 3 redundancy. The exhibit shows the proposal for these switches. Which change to the proposal will help meet the company’s requirements?A . The proposed switches should be replaced with switches such as the...
Which spanning tree implementation meets this goal?
Refer to the exhibits. Exhibit 1. Exhibit 2. The company wants to minimize congestion on Link 1. Which spanning tree implementation meets this goal?A . Instance 1 = VLANs 4-5 Instance 2 = VLANs 6-7Switch 2 instance 1 priority = 0 Switch 2 instance 2 priority = 1Switch 3 instance...