- All Exams Instant Download
How can the administrator achieve this goal?
A network administrator wants to be able to access an Aruba Instant cluster at the same IP address even if the current master fails. How can the administrator achieve this goal?A . Configure a VC IP address that is a reserved IP address in the AP's subnet.B . Configure the...
What is one reason to use OSPF routing instead of static routing?
A company has a single routing protocol environment. What is one reason to use OSPF routing instead of static routing?A . OSPF allows ArubaOS switches to use default routes, while static routes cannot use 0.0.0.0/0 as the destination network.B . OSPF has a lower default administrative distance than static routing...
What should the administrator do to achieve this goal?
An ArubaOS switch provides PoE+ several Aruba APs. Users might also connect PoE devices to the is switch. In a situation where the switch PoE capacity is exceeded, the network administrator wants to ensure that the switch continues to power the IPs in preference to other devices. What should the...
How does AirWave determine which configuration template to apply to these switches?
A network administrator wants to use Aruba AirWave to manage Aruba 3810 Series switches deployed at the campus access layer. How does AirWave determine which configuration template to apply to these switches?A . based on the global group associated with their groupB . based o their lowest level subfolderC ....
Which action does the standby member take if it sends a probe but receives no response?
A Virtual Switching Framework (VSF) fabric is configured to use LLDP-MAD. Which action does the standby member take if it sends a probe but receives no response?A . It sends a request packet to the commander to determine which ports should remain active.B . It continues to function and assumes...
Which issue could cause the Blocked status on A2?
Refer to the Exhibit: Which issue could cause the Blocked status on A2?A . A1 and A2 are connected to different switches.B . A1 and A2 use different trunk load balancing modes.C . A1 and A2 have spanning tree enabled on the link aggregation.D . A1 and A2 support different...
What should the administrator do to restore communication?
A network administrator discovers and then authorizes several ArubaOS switches in Aruba AirWave. Immediately after the administrator authorizes the switches, AirWave cannot communicate with the switches anymore. What should the administrator do to restore communication?A . Change the SNMP and Telnet/SSH credentials in the AirWave global communication settings to match...
Where should the network administrator configure an IP helper address of 10.1.1.10?
Refer to the exhibit. All of the switches shown in the exhibit are ArubaOS switches. Where should the network administrator configure an IP helper address of 10.1.1.10?A . on VLAN 2 on Switch-1B . on VLAN 2 on Switch-3C . on VLAN 1 on Switch-1D . on VLAN 1 on...
How should the network administrator configure the link between Switch A and Switch B to ensure that all hosts can communicate to all the other hosts within their respective VLANs?
Refer to the exhibit. The network consists of two ArubaOS switches with routing disabled. How should the network administrator configure the link between Switch A and Switch B to ensure that all hosts can communicate to all the other hosts within their respective VLANs?A . tagged for VLAN 20 and...
Which settings should match on physical interfaces before a network combines them in a link aggregation?
Which settings should match on physical interfaces before a network combines them in a link aggregation?A . speed and duplex modeB . DSCP and mediaC . speed and VLANsD . LLDP TLVs and VLAnsView AnswerAnswer: A
