HPE2-W09 exam

Your task is to configure an EVPN solution for a dual-stack IPv4 and IPv6 protocol in the overlay networks. Is this statement about EVPN and IPv6 correct? Solution: Different virtual MAC must be used for IPv4 andIPv6 Active Gateway.A . YesB . NoView AnswerAnswer: B

Does this correctly describe Network Analytics Engine (NAE) limitations on ArubaOS-CX switches? Solution: Different switches have different limitations for the number of NAE scripts, monitors, and agents supported.A . YesB . NoView AnswerAnswer: B

Is this part of a valid strategy for load sharing traffic across the links in an Ethernet Ring Protection Switching (ERPS) ring? Solution: Implement Virtual Switching Extension (VSX) on pairs of ERPS switches at the same site. Then combine multiple links between two data centers into VSX LAGs (M-LAGs).A ....

The architect designs a spine and leaf network for a single data center that will use multiple leaf switches as Virtual Tunnel End Points (VTEP). The architect needs to select the type of Integrated Routing & Bridging (IRB) for the solution. Is this statement about the IRB type true? Solution:...

Does this correctly describe routing information advertised by a VXLAN Tunnel Endpomt (VTEP) that uses EVPN? Solution: MAC/IP advertisement routes advertise the MAC addresses that can be reached through the VTEP.A . YesB . NoView AnswerAnswer: B

You plan to use multi-protocol BGP to implement dynamic VRF route leaking on an ArubaOS-CX switch. Is this a rule for the setup? Solution: You can only leak routes between up to three VRFs.A . YesB . NoView AnswerAnswer: A

Is this a use case for deploying Ethernet Ring Protection Switching (ERPS)? Solution: connecting multiple data centers at Layer 2 while minimizing the number of dark fiber connections requiredA . YesB . NoView AnswerAnswer: B

Does this correctly describehow the Virtual Switching Extension (VSX) fabric reacts to various component failure scenarios? Solution: The keepalive goes down, ISL link remains up. Switch-1 and Switch-2 remains up. The Split-recovery mode is disabled. In this case the secondary switch shutdowns Svls.A . YesB . NoView AnswerAnswer: B

Refer to the exhibit. You are adding a VLAN 30, subnet 10.0.30.0/24 to the network shown in the exhibit. (This network is simplified to just the relevant switches for this item.) This subnet belongs in VRF A, and you have added a Layer 3 VLAN 30 interface attached to this...

Two ArubaOS-CX switches ate part of a Virtual Switching Extension (V5X) fabric. Is this a guideline for configuring the switches' link-up delay settings? Solution: Set the link-up delay timer based on the number of MAC forwarding, ARP, and routing table entries.A . YesB . NoView AnswerAnswer: B