A network consisting of switches does not have STP enabled. A Layer 2 loop must occur.

A network consisting of switches does not have STP enabled. A Layer 2 loop must occur.A . TrueB . FalseView AnswerAnswer: B

April 2, 2021 No Comments READ MORE +

The IKE protocol is used to establish an SA for IPsec auto-negotiation, which can support identity authentication when the address of the initiator of the negotiation changes dynamically.

The IKE protocol is used to establish an SA for IPsec auto-negotiation, which can support identity authentication when the address of the initiator of the negotiation changes dynamically.A . TrueB . FalseView AnswerAnswer: A

April 2, 2021 No Comments READ MORE +

As shown, the topology and the configuration on the switch interconnect port, you can determine that the data frame labeled as VLAN 10 can be forwarded normally between the two switches.

As shown, the topology and the configuration on the switch interconnect port, you can determine that the data frame labeled as VLAN 10 can be forwarded normally between the two switches. A . TrueB . FalseView AnswerAnswer: B

April 2, 2021 No Comments READ MORE +

When a port running the standard STP protocol receives a suboptimal BPDU, it immediately sends its own configuration BPDU from this port.

When a port running the standard STP protocol receives a suboptimal BPDU, it immediately sends its own configuration BPDU from this port.A . TrueB . FalseView AnswerAnswer: A

April 2, 2021 No Comments READ MORE +

Which of the following statements about OSPF neighbor status is correct? (Multiple Choice)

Which of the following statements about OSPF neighbor status is correct? (Multiple Choice)A . In the Exchange state, the routers send each other a DD packet containing the summary of the link state information to describe the content of the local LSDC . The master-slave relationship of OSPF is formed...

April 2, 2021 No Comments READ MORE +

Which method does the PPPoE client use to send PADI packets to the Server?

Which method does the PPPoE client use to send PADI packets to the Server?A . BroadcastB . UnicastC . MulticastD . AnycastView AnswerAnswer: A

April 2, 2021 No Comments READ MORE +

Which of the following commands can implement this requirement?

The network as shown in the following figure, when the network administrator performs traffic planning, it is expected that the packets sent by Host A to Host B will be connected to G0/0/3 interface between the routers. The packets sent by Host B to Host A go pass the G0/0/4...

April 2, 2021 No Comments READ MORE +

The ARP protocol can resolve the MAC address of the target device according to the destination IP address, thereby, to map the link layer address and the IP address.

The ARP protocol can resolve the MAC address of the target device according to the destination IP address, thereby, to map the link layer address and the IP address.A . TrueB . FalseView AnswerAnswer: A

April 1, 2021 No Comments READ MORE +

Which fields in the IPv4 header are related to sharding? (Multiple Choice)

Which fields in the IPv4 header are related to sharding? (Multiple Choice)A . Fragment OffsetB . FlagsC . TTLD . IdentificationView AnswerAnswer: ABD

April 1, 2021 No Comments READ MORE +

Which of the following ACLs should be used on the G0/0/3 interface of the router?

The network shown in the following figure requires the network where the host is located to access the Internet through Easy IP. Which of the following ACLs should be used on the G0/0/3 interface of the router?A . acl number 2000 rule 5 permit source 10.0.13.1 0.0.0.0 #B . acl...

April 1, 2021 No Comments READ MORE +