- All Exams Instant Download
What is the purpose of the DHCP Relay Agent?
What is the purpose of the DHCP Relay Agent?A . Forwards DHCP requests from a client to the server on another subnetB . Forwards DHCP responses from one server to clientsC . Broadcasts DHCP requests from clients to all serversD . Assigns network addresses and subnet masks to DHCP clients...
In a PIM Sparse Mode based multicast topology, what role does the Rendezvous Point provide?
In a PIM Sparse Mode based multicast topology, what role does the Rendezvous Point provide?A . The node is used to provide (S,G) across a Layer 3 boundary.B . The location PIM sends traffic before invoking SPT.C . The node is used to provide (*,G) on a Layer 2 shared...
What will happen when a network administrator enters the shutdown command?
Refer to the exhibit. What will happen when a network administrator enters the shutdown command?A . Maintains existing BGP sessions but no longer establishes new onesB . Terminates any established BGP sessions for the specified neighborC . Stops any traffic from being sent on the physical interface used to reach...
Which Ethernet interface speeds do Dell Networking OS10 switches support?
Which Ethernet interface speeds do Dell Networking OS10 switches support?A . 10, 16, and 40GbB . 1, 10, and 25GbC . 1, 2, and 100GbD . 4, 8, and 32GbView AnswerAnswer: B
What is the minimum multicast configuration level required on the router?
A router needs to be configured to allow multiple multicast servers for the same group to be presented only to ports where active listeners reside. Each listener may exclude non-preferred servers. What is the minimum multicast configuration level required on the router?A . IGMPv3 without snooping PIM-SSMB . IGMPv2 with...
How will the reload of these switches proceed to result in the default initial state?
Two (2) Dell EMC Networking OS10 switches in a VLT configuration need to be upgraded. How will the reload of these switches proceed to result in the default initial state?A . Reload the primary VLT node. This process will automatically trigger the reload of the secondary node after it has...
What is the default PIM-SSM IP range?
What is the default PIM-SSM IP range?A . 224.0.0.0/4B . 224.0.0.0/24C . 232.0.0.0/8D . 232.0.0.0/4View AnswerAnswer: C
Which command offers a solution to the inability to ping the host address from S1?
Refer to the exhibit: From S1, a ping to the host address of 192.168.37.3 is not successful. The routing table on S1 shows three directly connected networks (including the Lo0 network of S1). Network 192.168.34.0/24 and the Lo0 networks of S2 and S3 are the only OSPF-learned networks in the...
Match the IGMP versions and features in the source column to the feature or version where they first appeared. There are more packet descriptions than IGMP versions.
Match the IGMP versions and features in the source column to the feature or version where they first appeared. There are more packet descriptions than IGMP versions.A . IGMP Version 1 - a) Queries can be sent out either as general queries or group-specific queries IGMP Version 2 - b)...
What is an advantage of running LLDP?
What is an advantage of running LLDP?A . Automatic error detection and correction of the portB . Reduces spanning-tree convergenceC . Provides detailed software version informationD . Simplifies the use of network managementView AnswerAnswer: D
