- All Exams Instant Download
How many broadcast domains are created by the switch?
A network administrator created three VLANs on an Ethernet switch. How many broadcast domains are created by the switch?A . 1B . 2C . 3D . 4View AnswerAnswer: C
Which subnet mask meets this requirement?
A network administrator wants to use a subnet that will only have two host addresses. Which subnet mask meets this requirement?A . 255.255.255.248B . 255.255.255.252C . 255.255.255.254D . 255.255.255.256View AnswerAnswer: B
Which operating system does an N-Series switch use?
Which operating system does an N-Series switch use?A . OS 3B . OS 6C . OS 9D . OS 10View AnswerAnswer: B
Which platforms are supported by the Dell EMC Networking OS (DNOS) 6?
Which platforms are supported by the Dell EMC Networking OS (DNOS) 6?A . N1500 Series switch and N2000 Series switchB . N1700 Series switch and N1500 Series switchC . N1700 Series switch and N3500 Series switchD . N3500 Series switch and N2000 Series switchView AnswerAnswer: A
Which Layer 2 technology is used to segment a switched network?
Which Layer 2 technology is used to segment a switched network?A . TrunkingB . ISLC . LAND . VLANView AnswerAnswer: D
In addition to receiving an IP address, what other information is obtained from a DHCP server?
In addition to receiving an IP address, what other information is obtained from a DHCP server?A . Default gateway address and VLAN IDB . DNS server address and port speedC . Default gateway address and DNS server addressD . DNS server address and VLAN IDView AnswerAnswer: C
Which type of route is often used to direct traffic bound for the Internet?
Which type of route is often used to direct traffic bound for the Internet?A . RedistributedB . Directly connectedC . DynamicD . DefaultView AnswerAnswer: D
Which OS6 command is used to verify the running configuration on port 4?
Which OS6 command is used to verify the running configuration on port 4?A . # show running-config int eth 1/0/4B . # show running-config int gi 1/0/4C . # show running-configuration int gi 1/1/4D . # show running-configuration interface ethernet 1/1/4View AnswerAnswer: B
What is a possible cause of this issue?
A technician configures RIP on a new N-Series switch to connect to an existing switch that runs RIP. The routing table is not populating even after the network statements are added. What is a possible cause of this issue?A . The existing switch has not been configured with the command...
Which command is used to prevent STP learning on a port that is connected to a server?
Which command is used to prevent STP learning on a port that is connected to a server?A . #able spanning-treeB . #spanning-tree securityC . #spanning-tree portfastD . #spanning-tree offView AnswerAnswer: C
