- All Exams Instant Download
What accurately describes the Network Time Protocol (NTP)?
What accurately describes the Network Time Protocol (NTP)?A . Implemented on a Dell EMC Network OS 6.B . Time synchronization algorithms do not account for clock driftC . Client synchronizes among a set of distributed time servers.D . Client makes sudden changes in time to keep synchronized.View AnswerAnswer: C
What accurately describes the comparison between stacking and VLT?
What accurately describes the comparison between stacking and VLT?A . VLT allows for more physical devices to appear as one virtual device than stacking does.B . Stacked switches share a common control plane while VLT peers maintain their own control planeC . Stacked switches and VLT peers allow “single pane...
Which IP address belongs to the same subnet as 192.168.8.10/22?
Which IP address belongs to the same subnet as 192.168.8.10/22?A . 192.168.1.192B . 192.168.5.16C . 192.168.10.1D . 192.168.0.3View AnswerAnswer: C
Under which column in the output of the show mac-address-table command is this information displayed?
A network administrator needs to identify which MAC addresses are static. Under which column in the output of the show mac-address-table command is this information displayed?A . InterfaceB . TypeC . MAC addressD . StateView AnswerAnswer: B
Which command sequence leads to the successful creation of a Layer 3 port channel on an OS10 switch?
Which command sequence leads to the successful creation of a Layer 3 port channel on an OS10 switch?A . 1(config-if-po-2)# ip address 192.168.0.0/31 S1(config-if-po-2)# no switchportB . S1(config-if-po-2)# ip address 192.168.0.0/31 S1(config-if-po-2)# no switchportC . S1(config-if-po-2)# ip address 192.168.0.0/31 S1(config-if-po-2)# switchport mode IPv4D . S1(config-if-po-2)# no switchport S1(config-if-po-2)# ip address...
How many broadcast domains are created by the switch?
A network administrator created three VLANs on an Ethernet switch. How many broadcast domains are created by the switch?A . 1B . 2C . 3D . 4View AnswerAnswer: C
What is a possible cause of this issue?
A technician configures RIP on a new N-Series switch to connect to an existing switch that runs RIP. The routing table is not populating even after the network statements are added. What is a possible cause of this issue?A . The existing switch has not been configured with the command...
Which command is available in OS6 to verify jumbo frames?
Which command is available in OS6 to verify jumbo frames?A . show interfaces countersB . show hardware dropsC . show interface flowcontrolD . show interfaces configView AnswerAnswer: A
Which subnet mask provides only two valid IP addresses that can be assigned to hosts?
Which subnet mask provides only two valid IP addresses that can be assigned to hosts?A . 255.255.255.248B . 255.255.255.254C . 255.255.255.252D . 255.255.255.256View AnswerAnswer: C
Which type of route is often used to direct traffic bound for the Internet?
Which type of route is often used to direct traffic bound for the Internet?A . RedistributedB . Directly connectedC . DynamicD . DefaultView AnswerAnswer: D
