- All Exams Instant Download
Which two of the following are true regarding the BGP Prefix-Based outbound route filtering feature?
Which two of the following are true regarding the BGP Prefix-Based outbound route filtering feature? (Choose two.)A . IP multicast routes are not supported.B . Outbound route filtering is configured only on a per-address family basis.C . Outbound route filtering can be configured for either iBGP or eBGP sessions.D ....
Please Answer Questions Follow The Prompts Below
DRAG DROP View AnswerAnswer:
When configuring Cisco IOS XR route policy nesting, which command is used within a route policy to call another route policy?
When configuring Cisco IOS XR route policy nesting, which command is used within a route policy to call another route policy?A . applyB . continueC . jumpD . gotoE . callView AnswerAnswer: A
C
C. No BGP attributes are changed in EBGP updates except for the next-hop attribute if next-hop-self is configured. D. Routes learned from an EBGP peer not advertised to another EBGP peer to prevent routing information loops. E. IBGP uses split horizon to prevent routing information loops; routes learned from an...
When using the show bgp ipv6 unicast summary command to verify the IPv6 BGP session status with the IPv6 BGP peers, you noticed the "St/PfxRcd" status for one of the IPv6 BGP peers is in the "Active" state. What does the "Active" state indicate?
When using the show bgp ipv6 unicast summary command to verify the IPv6 BGP session status with the IPv6 BGP peers, you noticed the "St/PfxRcd" status for one of the IPv6 BGP peers is in the "Active" state. What does the "Active" state indicate?A . The IPv6 BGP session has...
Which statement Is correct regarding the DR election process In this OSPF implementation?
Which statement Is correct regarding the DR election process In this OSPF implementation? A . Both the CE5 and PE6 routers are DROTHERsB . PE5 is the OSPFv2 DR for the GigabitEthernet link between PE5 and PE6C . PE6 is the OSPFv2 and OSPFv3 DR for the GigabitEthernet link between...
Which three statements are true regarding the OSPF router ID? (Choose three.)
Which three statements are true regarding the OSPF router ID? (Choose three.)A . The OSPF routing process chooses a router ID for itself when it starts up.B . The router-id command is the preferred procedure to set the router ID . If a loopback interface is configured, its address will...
When configuring BGP on Cisco IOS XR Software, which address-family is enabled by default?
When configuring BGP on Cisco IOS XR Software, which address-family is enabled by default?A . IPv4 unicastB . IPv6 unicastC . VPNv4D . IPv4 unicast and IPv6 unicastE . IPv4 unicast and IPv6 unicast and VPNv4F . No address-family is enabled by default.View AnswerAnswer: F
When troubleshooting OSPF neighbor errors, which three verification steps should be considered.? (Choose three.)
When troubleshooting OSPF neighbor errors, which three verification steps should be considered.? (Choose three.)A . Verify if neighboring OSPF interfaces are configured in the same area.B . Verify if neighboring OSPF interfaces are configured with the same OSPF process ID . Verify if neighboring OSPF interfaces are configured with the...
Please Answer Questions Follow The Prompts Below
DRAG DROP View AnswerAnswer:
