- All Exams Instant Download
When using the Cisco IOS-XR show bgp command to examine the BGP table, the Metric value being displayed is used to represent which BGP attribute?
When using the Cisco IOS-XR show bgp command to examine the BGP table, the Metric value being displayed is used to represent which BGP attribute?A . WeightB . Local PreferenceC . MEDD . Cost CommunityView AnswerAnswer: C
When configuring BGP on Cisco IOS XR Software, which address-family is enabled by default?
When configuring BGP on Cisco IOS XR Software, which address-family is enabled by default?A . IPv4 unicastB . IPv6 unicastC . VPNv4D . IPv4 unicast and IPv6 unicastE . IPv4 unicast and IPv6 unicast and VPNv4F . No address-family is enabled by default.View AnswerAnswer: F
When configuring Cisco IOS route maps, which command allows the route map processing to jump to another statement instead of exiting?
When configuring Cisco IOS route maps, which command allows the route map processing to jump to another statement instead of exiting?A . jumpB . nextC . setD . continueE . gotoView AnswerAnswer: D
Which two configuration options can be used to optimize the IS-IS network scenario?
Refer to the exhibit. Which two configuration options can be used to optimize the IS-IS network scenario? (Choose two.)A . Change the R1 and R2 IS type to Level 2.B . Change the R1 and R2 IS type to Level 1.C . Change the gi0/0 interface IS-IS circuit type on...
What are two ways to advertise networks into BGP? (Choose two.)
What are two ways to advertise networks into BGP? (Choose two.)A . using the neighbor router BGP commandB . using a route policy in Cisco IOS XR Software or using a route map in Cisco IOS Software or Cisco IOS XE SoftwareC . using route redistribution into BGPD . using...
The S bit in the MPLS header is used for what purpose?
The S bit in the MPLS header is used for what purpose?A . To indicate the bottom level in the label stackB . To indicate if LDP is sync to the IGPC . To indicate if LDP is sync to the IGPD . To indicate the status of the LSPView...
Which statement correctly describes this route policy?
Refer to the Cisco IOS-XR route policy exhibit. Which statement correctly describes this route policy?A . The pass action is required after each of the set community statements to make this route policy functional.B . If a route has both the 11:11 and 22:22 communities (or 44:44 and 22:22), the...
How can you prevent multihomed customers with connections to two service providers from acting as a transit AS?
How can you prevent multihomed customers with connections to two service providers from acting as a transit AS?A . Enable BGP synchronization on all the customer routers.B . Use MED to influence the inbound traffic from the ISPs.C . Use static routing to the ISPs.D . Use an AS-path access-list...
Please Answer Questions Follow The Prompts Below
DRAG DROP View AnswerAnswer:
Which two of the following are true regarding the BGP Prefix-Based outbound route filtering feature?
Which two of the following are true regarding the BGP Prefix-Based outbound route filtering feature? (Choose two.)A . IP multicast routes are not supported.B . Outbound route filtering is configured only on a per-address family basis.C . Outbound route filtering can be configured for either iBGP or eBGP sessions.D ....
