- All Exams Instant Download
Which two configurations are required to accomplish this goal?
Refer to the exhibit. A service provider engineer has a requirement to configure an Inter-AS L3VPN with a maximum of one LSP between PE-1 and PE-2. Which two configurations are required to accomplish this goal? (Choose two)A . next-hop-self on ASBR'sB . redistribute bgp on ASBR'sC . nest-hop-self on RR'sD...
Which Cisco GBIC achieves this goal?
A network engineer needs to connect two core switches that use Gigabit Ethernet interfaces in an MPLS backbone and that are separated by a distance of 60 km. Which Cisco GBIC achieves this goal?A . Cisco 1000BASE-T GBICB . Cisco 1000BASE-SX GBICC . Cisco 1000BASE-LX/LH GBICD . Cisco 1000BASE-ZX GBICView...
Which solution meets these requirements?
A network operation engineer has these requirement: • prevent multicast transit when it is enforced by unicast stub routing. • Reduce the overall processing of PIM control traffic. Especially when the number of stub links increases on the stub device. • protect against multicast spoofing of PM designated router messages...
Which configuration must be applied on both PE routers to avoid the routing loop?
Refer to the exhibit. CE6 cannot ping the loopback address of C7.An SP engineer notices a routing loop between PE2 and CE4. Which configuration must be applied on both PE routers to avoid the routing loop?A . Neighbor<CE-IP address>soo<value> with the same SoO value on both PEsB . Neighbor<CE-IP address>soo<value>...
Which RP mechanism uses the TTL value to scope the RP address within the multicast domain?
Which RP mechanism uses the TTL value to scope the RP address within the multicast domain?A . Auto-RPB . Embedded RPC . Anycast RPD . BSRView AnswerAnswer: A
Which IPv6 transition mechanism allows ISP_X to provide IPv6 connected by leveraging the existing MPLS IPv4 core network?
ISP_X has IPv4 only enabled in the MPLS backbone. ISP_X must provide IPv6 services to its customers including IPv6 Internet access. Which IPv6 transition mechanism allows ISP_X to provide IPv6 connected by leveraging the existing MPLS IPv4 core network?A . 6to4 tunnelsB . NAT444C . 6PED . NAT64E . 6RDF...
Which label protocol should the backbone carrier use to provide the proper connectivity that the ISP_A requires?
A backbone carrier is approached by an ISP_A which provides L3VPN services. The ISP_A requires MPLS VPN services from the backbone carrier to establish connectivity between the two POPs of the ISP_A. Which label protocol should the backbone carrier use to provide the proper connectivity that the ISP_A requires? A....
Which three IS-IS TLVs floods the MPLS TE resource allocation information through the network?
Which three IS-IS TLVs floods the MPLS TE resource allocation information through the network? (Choose three)A . Traffic engineering router IDB . Extended IP reachabilityC . IS TE reachabilityD . RSVPE . Extended IS reachabilityF . OpaqueView AnswerAnswer: A, B, E
Which solution meets this requirement?
A corporate ABC located in the US acquired Company XYZ which is located in Europe. Both companies are connected to the internet using the local ISP. A management VLAN must built using subnet 192.168.1.0/24 across the ABC and XYZ sites. Which solution meets this requirement?A . Layer 3 VPNB ....
Which option is the correct configuration?
A network engineer is configuring a POS interface on Cisco router running a cisco IOS Software. The POS interface must permit logging of payload label and C2 mismatch SONET/SDN alarms. Which option is the correct configuration? Interface pos<number> Pos report pplmA . Interface pos<number> Pos report allB . Interface pos<number>...
