- All Exams Instant Download
Which configuration achieves this goal?
A network engineer has a requirement to configure IP flow exporting using standard protocols on a cisco IOS XE device. Which configuration achieves this goal?A . flow exporter EXPORTER destination 10.1.1.1 export-protocol version 9 transport udp 90B . flow exporter EXPORTER destination 10.1.1.1 source Loopback 0 transport udp 90C ....
Which protocol provides fast link failure detection for all type of encapsulation?
Which protocol provides fast link failure detection for all type of encapsulation?A . Prefix Independent ConvergenceB . Carrier delayC . Non stop forwardingD . Bidirectional forwarding detectionView AnswerAnswer: D
Refer to the exhibit, Which feature does this OSPF database entry refer to?
Refer to the exhibit, Which feature does this OSPF database entry refer to?A . Intra-autonomous traffic engineerB . Inter-autonomous traffic engineerC . Segment routingD . mVPNE . LFA repair path attributesView AnswerAnswer: A
Which component does NSF rely on to ensure that interfaces remain up during switchover and that lower layer protocol state is maintained?
Which component does NSF rely on to ensure that interfaces remain up during switchover and that lower layer protocol state is maintained?A . SSOB . BFDC . IP FRRD . LFAView AnswerAnswer: A
What is the status of the L2 tunnel between PE1, PE2 and the layer 2 switches?
Refer to the exhibit. What is the status of the L2 tunnel between PE1, PE2 and the layer 2 switches?A . The layer 2 tunnel is down due to the ACL is applied on the PE2 interfaceB . The layer 2 tunnel is up and SW1 become the root bridge...
Which command can be issued on R9 so that R12 receives all its internal and external OSPF routes inside the R12 BGP table?
Refer to the exhibit. Which command can be issued on R9 so that R12 receives all its internal and external OSPF routes inside the R12 BGP table?A . redistribute ospf 1 internal external 1 external 2B . redistribute ospf 1 match nssa-external 1 nssa-external 2C . redistribute ospf 1 internal...
Which technology is a forwarding decision point in a PE router that provides flexibility to make many Layer 2 flow decisions within an interface?
Which technology is a forwarding decision point in a PE router that provides flexibility to make many Layer 2 flow decisions within an interface?A . pseudowireB . AToMC . VPLSD . local connectE . EFPView AnswerAnswer: E
Which action satisfies this requirement?
Two MPLS VPN customers want to acquire Internet access. They make use of overlapping address space but do not want to use NAT on the CPEs. Which action satisfies this requirement?A . Configure each VRF with a default route in the global table by using a static route toward each...
According to RFC 3107, which solution achieves this goal?
A service provider engineering team must design a solution that supports end-to-end LSPS for multiple IGP domains within different AS numbers. According to RFC 3107, which solution achieves this goal?A . LDP and BGPB . BGP and Send-labelC . RSVP and IS-IS or OSPFD . RSVP and BGPE . mLDPView...
Which two solutions can prevent the multicast traffic from being affected by the RPF check failure due to the MPLS TE tunnel deployment?
Refer to the exhibit. IPTV video clients are connected to R6. Unicast and multicast traffic flows from R1 to R6. The OSPF cost of the R1-R2-R3-R6 path is lower than the R1-R5-R4-R3-R6 path To enable load sharing and fast reroute, the design team decided to implement MPLS TE tunnels between...
