- All Exams Instant Download
For the Cisco ASR 1000 Series, which module provides the physical and electrical terminal for the shared port
For the Cisco ASR 1000 Series, which module provides the physical and electrical terminal for the shared portA . SPAB . RPC . ESPD . SIPView AnswerAnswer: A
What ISIS TLVs are used to support MPLS traffic Engineering? (Choose three)
What ISIS TLVs are used to support MPLS traffic Engineering? (Choose three)A . TLV 22 Extended IS neighborB . TLV 10 Authentication InformationC . TLV 134 Router IDD . TLV 132 IP interface AddressE . TLV 128 IP Internal ReachabilityF . TLV 135 IS ReachabilityView AnswerAnswer: A, C, F
Which two components does the LDP use to discover neighbors on a network segment? (Choose two)
Which two components does the LDP use to discover neighbors on a network segment? (Choose two)A . 224.0.0.14 multicast addressB . 224.0.0.1 multicast addressC . 224.0.0.2 multicast addressD . 711 tcp portE . 646 udp portF . 711 udp portG . 646 tcp portView AnswerAnswer: C, E
What is the status of the L2 tunnel between PE1, PE2 and the layer 2 switches?
Refer to the exhibit. What is the status of the L2 tunnel between PE1, PE2 and the layer 2 switches?A . The layer 2 tunnel is down due to the ACL is applied on the PE2 interfaceB . The layer 2 tunnel is up and SW1 become the root bridge...
Which are the two reasons for this issue?
Refer to the exhibit. The NOC team received multiple reports about poor quality of the VoIP traffic. An engineer notices that all VoIP traffic with poor quality uses Core links with QoS implemented. Which are the two reasons for this issue? (Choose two)A . A DoS attack on the core...
Which are the two purposes of the MPLS label value 1? (Choose two.)
Which are the two purposes of the MPLS label value 1? (Choose two.)A . It indicates an implicit null labelB . It is used to carry the QoS value in the label stackC . It is used for VPNv6 packetsD . It is used for MPLS OAM packetsE . It...
In a PE-CE scenario using OSPF as the routing protocol a down-bit set can be advertised in which OSPF LSA type?
In a PE-CE scenario using OSPF as the routing protocol a down-bit set can be advertised in which OSPF LSA type?A . Type 1 LSAB . Type 2 LSAC . Type 3 LSAD . Type 4LSAView AnswerAnswer: C
What is the main different between an SNMP trap and a syslog message?
What is the main different between an SNMP trap and a syslog message?A . SNMP traps are formally defined in a MIB, and syslog body contents are not formally definedB . SNMP traps are forwarded to EMS systems and syslog messages are forwarded to any NMS systemC . SNMP traps...
Refer to the exhibit. In regard to the traffic that is flowing from CE1 in the direction of CE2, what is the label stack in the packets that are leaving R6?
Refer to the exhibit. In regard to the traffic that is flowing from CE1 in the direction of CE2, what is the label stack in the packets that are leaving R6?A . {16}B . {16 25}C . {25}D . {0 25}View AnswerAnswer: D
Which two cabling methods reflect the minimum configuration needed for full synchronization between the two Cisco ASR 9000 chassis?
A service provider is implementing an nV Edge system with the two ASR 9000 chassis has two RSPs. Which two cabling methods reflect the minimum configuration needed for full synchronization between the two Cisco ASR 9000 chassis? (Choose two)A . Create the single virtual control plane that connect the two...
