Which protocol does prime collaboration Assurance use to poll the health status of different systems in the collaboration environment?

Which protocol does prime collaboration Assurance use to poll the health status of different systems in the collaboration environment?A . SIPB . SMTPC . SCCPD . SNMPView AnswerAnswer: D

May 15, 2021 No Comments READ MORE +

To where does the call retreat?

Refer to the exhibit A user takes a phone from San Francisco to New York for a short reassignment. The phone was set up to use the San Francisco device pool, and device mobility is enabled on the Cisco UCM. The user makes a call that matches a route pattern...

May 14, 2021 1 Comment READ MORE +

Which step will enable this feature?

An administrator must configure the local route group feature on cisco UCM. Which step will enable this feature?A . For each route list configure a route group to use as a Local Route Group.B . For each route pattern, select the Local Route Group as the destination.C . For each...

May 14, 2021 No Comments READ MORE +

Where is the default for maximum session Bit Rate for a region configured?

Where is the default for maximum session Bit Rate for a region configured?A . Region configurationB . Enterprise Phone configurationC . Service parameter configurationD . Enterprise parameters configurationView AnswerAnswer: C

May 14, 2021 No Comments READ MORE +

Which Codec is negotiated?

Refer to the exhibit. Which Codec is negotiated?B . 729C . ILBCE . 711ulawG . 728View AnswerAnswer: C

May 14, 2021 No Comments READ MORE +

What is the most efficient way to configure a speed dial to number 1111 on multiple phones using the Self-Provisioning feature in Cisco UCM?

What is the most efficient way to configure a speed dial to number 1111 on multiple phones using the Self-Provisioning feature in Cisco UCM?A . Configure each phone with the same DN and then configure a speed dial of 1111 on one of the phones manually by navigating to Devices>Phones...

May 13, 2021 No Comments READ MORE +

Which codec is negotiated when the SDP offer includes this line of text?

A Cisco IP Phone 7841 that is registered to a Cisco Unified Communications Manager with default configuration receives a call setup message. Which codec is negotiated when the SDP offer includes this line of text? M=audio 498181 RTP/AVP 0 8 97B . 711ulawC . iLBCE . 711alawG . 722View AnswerAnswer:...

May 13, 2021 No Comments READ MORE +

When a remote office location is set up with limited bandwidth resources, which codec carries the most voice calls?

When a remote office location is set up with limited bandwidth resources, which codec carries the most voice calls?B . 722D . 711F . 723H . 729View AnswerAnswer: D

May 13, 2021 No Comments READ MORE +

How does Cisco Unified Communications Manager perform a digit analysis on-hook versus off-hook for an outbound call from a Cisco IP phone that is registered to Cisco Unified CM?

How does Cisco Unified Communications Manager perform a digit analysis on-hook versus off-hook for an outbound call from a Cisco IP phone that is registered to Cisco Unified CM?A . On-hook, by pressing the digits and entering “#” to process the call, Unified CM performs a digit-by-digit analysis; off-hook, Unified...

May 13, 2021 No Comments READ MORE +

How many DNS SRV entries can be defined in the SIP trunk destination address field in Cisco Unified Communications Manager?

How many DNS SRV entries can be defined in the SIP trunk destination address field in Cisco Unified Communications Manager?A . 4B . 1C . 8D . 16View AnswerAnswer: B

May 13, 2021 No Comments READ MORE +