- All Exams Instant Download
Which command can be configured on routers R1 and R2 on fO/O interfaces to form OSPF adjacency?
TION NO: 91 Refer to the exhibit: R1 and R2 are directly connected with Fast Ethernet interfaces and have the above configuration applied OSPF adjacency is not formed. When the debug ip ospf hello command is issued on R1. these log messages are seen. Which command can be configured on...
Which MPLS design attribute can you use to provide Internet access to a major customer through a separate dedicated VPN?
Which MPLS design attribute can you use to provide Internet access to a major customer through a separate dedicated VPN?A . The customer that needs the Internet access service is assigned to the same RTs as the Internet gateway B. The Internet gateway inserts the full Internet BGP routing table...
Which IS-IS NET address configuration must be implemented on R3 to establish IS-IS connectivity?
Refer to the exhibit. An engineer with an employee 10:4350:47:853 is implementing IS-IS as the new routing protocol in the network. All routers in the network operate as Level 2 routers in the same private autonomous system, and the three branches are connected via dark fibre. The engineer has already...
Which protocol is used for communication between the PCE and PCC?
Which protocol is used for communication between the PCE and PCC?A . ICMP B. PCEP C. CEF D. POPView AnswerAnswer: B
Which route-map configuration must the administrator apply to router RTBH-1 to complete the implementation of RTBH services to CE-1?
Refer to the exhibit. ISP ASN 65100 provides Internet services to router CE-1 and receives customer prefix 198.18.18.0/24 via eBGP. An administrator for the ISP is now provisioning RTBH services to provide on-demand data-plane security for the customer’s IP space. Which route-map configuration must the administrator apply to router RTBH-1...
Which statement about this configuration is true?
Refer to the exhibit: This configuration is being applied on an IOS XR router. Which statement about this configuration is true?A . It is used to set up configuration to poll network data B. It is used to enable gRPC C. It is used to create a streaming subscription with...
What must the engineer configure to influence inbound path selection?
An engineer is trying to implement BGP in a multihomed architecture. What must the engineer configure to influence inbound path selection?A . A route map with WEIGHT attribute to control the inbound traffic. B. An offset list to set the metric for routes received from neighboring autonomous systems. C. An...
Which Cisco software OS uses monolithic architecture?
Which Cisco software OS uses monolithic architecture?A . NX-OS B. IOS XE C. IOS XR D. IOSView AnswerAnswer: D Explanation: Cisco Internetwork Operating System (IOS) is the software used on most Cisco Systems routers and current Cisco network switches. IOS is a package of routing, switching, internetworking and telecommunications functions...
Refer to the exhibit
DRAG DROP Refer to the exhibit. An engineer wants to determine Which paths are best, second best, third best, and fourth best. Drag and drop the peer addresses on the left to the corresponding BGP best-path selection order on the right. View AnswerAnswer: Explanation: Best C 50.50.50.2 2nd Best C...
Which additional task must the engineer perform on Router 1 so that all outbound traffic utilizes the link between R1 and R3 to reach ASN 4567?
Refer to the exhibit. An engineer is configuring path selection on router R1 for two ASNs as shown. Which additional task must the engineer perform on Router 1 so that all outbound traffic utilizes the link between R1 and R3 to reach ASN 4567?A . Configure a low weigh! on...
