- All Exams Instant Download
Which action causes the solution to fail?
Refer to the exhibit. A network engineer is configuring customer edge routers to finalize a L2VPN over MPLS deployment Assume that the AToM L2VPN service that connects the two CEs is configured correctly on the service provider network. Which action causes the solution to fail?A . A loopback with a...
Which task must the engineer perform as part of the deployment?
After a series of unexpected device failures on the network. a Cisco engineer is deploying NSF on the network devices so that packets continue to be forwarded during switchovers. The network devices reside in the same holding, but they are physically separated into two different data centers. Which task must...
What must the engineer configure to influence inbound path selection?
An engineer is trying to implement BGP in a multihomed architecture. What must the engineer configure to influence inbound path selection?A . A route map with WEIGHT attribute to control the inbound traffic. B. An offset list to set the metric for routes received from neighboring autonomous systems. C. An...
What is a feature of model-driven telemetry?
What is a feature of model-driven telemetry?A . It occasionally streams to multiple servers in the network. B. It is less secure because it uses community strings. C. It uses the pull model to send requested data to a client when polled. D. It uses the push model to stream...
Which configuration must the engineer apply to R2 to fix the problem?
Refer to the exhibit. A network engineer notices that router R2 is failing to install network 172.16.33.1/32 in the routing table. Which configuration must the engineer apply to R2 to fix the problem?A . R2(config)# access-list 1 permit 172.16.33.0 255.0.0.0 B. R2(config)# access-list 1 permit 172,16,33.0 255,255,255,0 C. R2(config)# access-list...
Which command is used to complete this configuration for QoS class-based marking?
Refer to the exhibit: Which command is used to complete this configuration for QoS class-based marking?A . PE-A(config-pmap-c)#set dscp ef B. PE-A(config-pmap-c)#fair-queue C. PE-A(config-pmap-c)#random-detect D. PE-A(config -pmap-c)#priorityView AnswerAnswer: A
Which configuration must the engineer apply on the network?
An engineer is developing a configuration script to enable dial-out telemetry streams using gRPC on several new devices. TLS must be disabled on the devices. Which configuration must the engineer apply on the network? A) B) C) D) A . Option A B. Option B C. Option C D. Option...
Which additional configuration is required for NetFlow to provide traceback information?
Which additional configuration is required for NetFlow to provide traceback information?A . Cisco Express Forwarding must be configured for traffic that is egressing from the router to be properly reported. B. A classification ACL must be configured to identify. Which type of traffic will be analyzed. C. The BGP routing...
Which configuration must an engineer apply to the two PE routers so that they validate reverse packet forwarding for packets entering their Gi2 interfaces and drop traffic from the RFC1918 space?
Refer to the exhibit. The CE router is peering with both PE routers and advertising a public prefix to the internet. Routing to and from this prefix will be asymmetric under certain network conditions, but packets must not be discarded. Which configuration must an engineer apply to the two PE...
Which result should the operator expect when trying to ping to an XR1 local address?
Refer to the exhibit. While troubleshooting the network, a network operator with an employee id: 3812:12:993 is trying to ping XR1. Which result should the operator expect when trying to ping to an XR1 local address?A . ICMP traffic works at a policed rate of 19 bytes per second every...
