- All Exams Instant Download
Which two configuration allow peering session to from between R1 and R2?
A network engineer configures BGP between R1 and R2. Both routers use BGP peer group CORP and are set up to use MD5 authentication. This message is logged to the console of router R1: “ May 5 39:85:55.469: %TCP-6-BADAUTH ” Invalid MD5 digest from 10.10.10.1 (29832) to 10.120.10.1 (179) tebleid...
Which method should an engineer use to deal with a long-standing contention issue between any two VMs on the same host?
Which method should an engineer use to deal with a long-standing contention issue between any two VMs on the same host?A . Adjust the resource reservation limitsB . Live migrate the VM to another hostC . Reset the VMD . Reset the hostView AnswerAnswer: A
What does the output confirm?
Refer to the exhibit. An engineer configures monitoring on SW1 and enters the show command to verify operation. What does the output confirm?A . SPAN session 1 monitors activity on VLAN 50 of a remote switchB . SPAN session 2 only monitors egress traffic exiting port FastEthernet 0/14.C . SPAN...
Which LISP component is required for a LISP site to communicate with a non-LISP site?
Which LISP component is required for a LISP site to communicate with a non-LISP site?A . ETRB . ITRC . Proxy ETRD . Proxy ITRView AnswerAnswer: C
Which deployment model meets this requirement?
A customer has several small branches and wants to deploy a WI-FI solution with local management using CAPWAP. Which deployment model meets this requirement?A . AutonomousB . Mobility ExpressC . SD-Access wirelessD . Local modeView AnswerAnswer: B
Which command accomplish this task?
Refer to the exhibit. An engineer must deny Telnet traffic from the loopback interface of router R3 to the loopback interface of router R2 during the weekend hours. All other traffic between the loopback interfaces of routers R3 and R2 must be allowed at all times. Which command accomplish this...
Which access point mode allows a supported AP to function like a WLAN client would, associating and identifying client connectivity issues?
Which access point mode allows a supported AP to function like a WLAN client would, associating and identifying client connectivity issues?A . client modeB . SE-connect modeC . sensor modeD . sniffer modeView AnswerAnswer: C Explanation: As these wireless networks grow especially in remote facilities where IT professionals may not...
Drag and drop the characteristics from the left onto the deployment models on the right
DRAG DROP Drag and drop the characteristics from the left onto the deployment models on the right. View AnswerAnswer:
Which command set is required?
An engineer must configure HSRP group 300 on a Cisco IOS router. When the router is functional, it must be the must be the active HSRP router. The peer router has been configured using the default priority value. Which command set is required?A . standby 300 priority 110 standby 300...
Which configuration change ensures that R1 is the active gateway whenever it is in a functional state for the 172.30.110.0724 network?
Refer to the exhibit. Which configuration change ensures that R1 is the active gateway whenever it is in a functional state for the 172.30.110.0724 network?A . R2 standby 1 priority 90 standby 1 preemptB . R2 standby 1 priority 100 standby 1 preemptC . R1 standby 1 preempt R2 standby...
