- All Exams Instant Download
Which command set must be configured on switch1 to achieve the following results on port fa0/1?
Refer to the Exhibit. Rapid PVST+ is enabled on all switches. Which command set must be configured on switch1 to achieve the following results on port fa0/1? ✑ When a device is connected, the port transitions immediately to a forwarding state. ✑ The interface should not send or receive BPDUs....
Which device makes the decision for a wireless client to roam?
Which device makes the decision for a wireless client to roam?A . wireless clientB . wireless LAN controllerC . access pointD . WCS location serverView AnswerAnswer: A
Which command set resolves this issue?
Refer to the Exhibit. An engineer attempts to configure a router on a stick to route packets between Clients, Servers, and Printers; however, initial tests show that this configuration is not working. Which command set resolves this issue? An engineer attempts to configure a router on a stick to route...
Which entity is responsible for maintaining Layer 2 isolation between segments In a VXLAN environment?
Which entity is responsible for maintaining Layer 2 isolation between segments In a VXLAN environment?A . switch fabricB . VTEPC . VNIDD . host switchView AnswerAnswer: C Explanation: VXLAN uses an 8-byte VXLAN header that consists of a 24-bit VNID and a few reserved bits. The VXLAN header together with...
Which action should the engineer use?
An engineer must create an EEM applet that sends a syslog message in the event a change happens in the network due to trouble with an OSPF process. Which action should the engineer use? event manager applet LogMessage event routing network 172.30.197.0/24 type allA . action 1 syslog msg "OSPF...
What is the function of a VTEP in VXLAN?
What is the function of a VTEP in VXLAN?A . provide the routing underlay and overlay for VXLAN headersB . dynamically discover the location of end hosts in a VXLAN fabricC . encapsulate and de-encapsulate traffic into and out of the VXLAN fabricD . statically point to end host locations...
What is the purpose of the LISP routing and addressing architecture?
What is the purpose of the LISP routing and addressing architecture?A . It creates two entries for each network node, one for Its identity and another for its location on the network.B . It allows LISP to be applied as a network visualization overlay though encapsulation.C . It allows multiple...
Which three elements determine Air Time efficiency? (Choose three)
Which three elements determine Air Time efficiency? (Choose three)A . evert-driven RRMB . data rate (modulation density) or QAMC . channel bandwidthD . number of spatial streams and spatial reuseE . RF group leaderF . dynamic channel assignmentView AnswerAnswer: BCD Explanation: https://www.ciscolive.com/c/dam/r/ciscolive/emea/docs/2020/pdf/BRKEWN-3010.pdf
Which technology does VXLAN use to provide segmentation for Layer 2 and Layer 3 traffic?
Which technology does VXLAN use to provide segmentation for Layer 2 and Layer 3 traffic?A . bridge domainB . VLANC . VRFD . VNIView AnswerAnswer: D Explanation: VXLAN has a 24-bit VXLAN network identifier (VNI), which allows for up to 16 million (= 224) VXLAN segments to coexist within the...
What is the difference between a RIB and a FIB?
What is the difference between a RIB and a FIB?A . The RIB is used to make IP source prefix-based switching decisionsB . The FIB is where all IP routing information is storedC . The RIB maintains a mirror image of the FIBD . The FIB is populated based on...
