- All Exams Instant Download
Which statement about the OPSF debug output is true?
Refer to the exhibit. Which statement about the OPSF debug output is true?A . The output displays OSPF hello messages which router R1 has sent or received on interface Fa0/1.B . The output displays OSPF messages which router R1 has sent or received on all interfaces.C . The output displays...
Which two descriptions of FlexConnect mode for Cisco APs are true? (Choose two.)
Which two descriptions of FlexConnect mode for Cisco APs are true? (Choose two.)A . APs that operate in FlexConnect mode cannot detect rogue APsB . FlexConnect mode is used when the APs are set up in a mesh environment and used to bridge between each other.C . FlexConnect mode is...
What is the difference between a RIB and a FIB?
What is the difference between a RIB and a FIB?A . The FIB is populated based on RIB content.B . The RIB maintains a minor image of the FID . The RIB is used to make IP source prefix-based switching decisions.E . The FIB is where all IP routing information...
Which configuration accomplishes this task?
The login method is configured on the VTY lines of a router with these parameters. - The first method for authentication is TACACS - If TACACS is unavailable, login is allowed without any provided credentials. Which configuration accomplishes this task? A. B. C. D. A. Option A B. Option B...
What does this EEM applet event accomplish? "event snmp oid 1.3.6.1.3.7.1.5.1.2.4.2.9 get-type next entry-op g entry-val 75 poll-interval 5"
What does this EEM applet event accomplish? "event snmp oid 1.3.6.1.3.7.1.5.1.2.4.2.9 get-type next entry-op g entry-val 75 poll-interval 5"A . It issues email when the value is greater than 75% for five polling cycles.B . It reads an SNMP variable, and when the value exceeds 75% for live polling cycles.C...
When reason could cause an OSPF neighborship to be in the EXSTART/EXCHANGE state?
When reason could cause an OSPF neighborship to be in the EXSTART/EXCHANGE state?A . Mismatched OSPF network typeB . Mismatched areasC . Mismatched MTU sizeD . Mismatched OSPF link costsView AnswerAnswer: C Explanation: When OSPF adjacency is formed, a router goes through several state changes before it becomes fully adjacent...
Which NGFW mode block flows crossing the firewall?
Which NGFW mode block flows crossing the firewall?A . PassiveB . TapC . Inline tapD . InlineView AnswerAnswer: D Explanation: Firepower Threat Defense (FTD) provides six interface modes which are: Routed, Switched, Inline Pair, Inline Pair with Tap, Passive, Passive (ERSPAN). When Inline Pair Mode is in use, packets can...
If a VRRP master router fails, which router is selected as the new master router?
If a VRRP master router fails, which router is selected as the new master router?A . router with the highest priorityB . router with the highest loopback addressC . router with the lowest loopback addressD . router with the lowest priorityView AnswerAnswer: A
What is the result of applying this access control list?
What is the result of applying this access control list? ip access-list extended STATEFUL 10 permit tcp any any established 20 deny ip any anyA . TCP traffic with the URG bit set is allowedB . TCP traffic with the SYN bit set is allowedC . TCP traffic with the...
Which feature must be configured to allow packet capture over Layer 3 infrastructure'?
Which feature must be configured to allow packet capture over Layer 3 infrastructure'?A . VSPANB . IPSPANC . RSPAND . ERSPANView AnswerAnswer: D Explanation: Encapsulated remote SPAN (ERSPAN): encapsulated Remote SPAN (ERSPAN), as the name says, brings generic routing encapsulation (GRE) for all captured traffic and allows it to be...
