- All Exams Instant Download
What is the cause of the issue?
You have an ACI environment with three APICs, two spine switches, and four-leaf switches. You wipe and reboot all APICs first then leaf and spine switches one-by-one and successfully go through the Initial Setuo dialogue on the APIC 1 CIMC KVM console. When you log in to the APIC1 WebGUI,...
Which action resolves the issue?
Refer to the exhibit. A network engineer upgrades the firmware of a Cisco Fabric Interconnect from boot flash. During the process, the fabric interconnect reboots and displays the message shown in the exhibit. Which action resolves the issue?A . Remove the service pack and upgrade through the auto-install procedure B....
Which action resolves the issue?
Refer to the exhibit. An engineer fails to implement a Cisco UCS Manager integration manager. The credentials and IP connectivity between Cisco APIC and UCS Manager are configured as expected. Which action resolves the issue?A . Disable HTTP to HTTPS redirection in Cisco UCS Manager B. Enable JSON API on...
Which action resolves the issue?
Refer to the exhibit. A network engineer configures OSPF protocol between two Cisco Nexus 7000 Series Switches. The OSPF neighbors fail to synchronize OSPF databases. Which action resolves the issue?A . Match the OSPF area between the two devices. B. Configure the IP addresses of the interface in the same...
Which two actions optimize the traffic?
A customer configures HSRP between two data centers that are interconnected with OTV. The configuration succeeds, but traffic between two ESXi virtual hosts on the same site is routed suboptimally through the OTV overlay. Which two actions optimize the traffic? (Choose two.)A . Disable first-hop redundancy. B. Filter HSRP traffic...
Which action resolves the issue?
Refer to the exhibit. RBAC is configured on the MDS switch for a new SAN administrator engineer to work on the FSPF configuration. However, after the configuration is applied the engineer who was assigned the FSPF_Admin role cannot perform any configuration changes. Which action resolves the issue?A . Write rule...
Which action resolves the issue?
A system administrator adds two vNICs to an existing service profile that is used to run a vSphere environment to support disjoint Layer 2 network connectivity. However, after the server is rebooted, the host is not accessible on the network. Which action resolves the issue?A . Remove all existing vNICs...
Which action resolves the issue?
Refer to the exhibit. An attempt to bind the Ethernet interface to vFC fails. Which action resolves the issue?A . Add the FCoE VLAN to the allowed VLAN list. B. Configure the FCoE VLAN that corresponds to the vFC VSAN as a private VLAN. C. Configure the interface as a...
Which statement about interface Ethernet 1/11 is true?
Refer to the exhibit. An engineer is performing a health check on ACI. Which statement about interface Ethernet 1/11 is true?A . The interface is working correctly and fully operational, but it is not in use. B. The interface policy is misconfigured. C. “out-of-service” is the default interface status in...
Which action resolves the issue?
An engineer configures FCoE between a set of ESXi hosts and a Cisco Nexus 5000 Series Switch. The Converged Network Adapter of the host fails to receive the response from the Cisco Nexus device. Also, the VFC interface is in a down state and the FIP adapter fails to receive...
