- All Exams Instant Download
Which action resolves the issue?
Refer to the exhibit. An engineer configures the server port on a Cisco Nexus 5000 Series Switch. The switch connects to an NPV edge switch port. The server fails to send the FC traffic to the fabric . Which action resolves the issue?A . Enable the NPIV mode on the...
Which action resolves the issue?
Cisco Unified Computing System Manager raises a critical error message that indicates that the system has overlapping Ethernet and FCoE VLANs. All of the Ethernet traffic on the overlapping VLANs drops . Which action resolves the issue?A . Modify the VLAN assignment to vNICs.B . Change the PIN groups on...
Which action resolves the connectivity issue?
Refer to the exhibit. An engineer is troubleshooting the connectivity between Server-1 and Server-2 . Which action resolves the connectivity issue?A . Enable BGP advertise pip feature on both leaf switchesB . Configure the same source IP address on NVE and virtual peer link on leaf switchesC . Classify CFS...
Which action resolves the issue?
A system administrator adds two vNICs to an existing service profile that is used to run a vSphere environment to support disjoint Layer 2 network connectivity. However, after the server is rebooted, the host is not accessible on the network. Which action resolves the issue?A . Remove all existing vNICs...
Which action resolves the issue?
Refer to the exhibit. An OSPF adjacency between Router-A and Router-B cannot reach the FULL state . Which action resolves the issue?A . Adjust the MTU on Router-A to 1600.B . Disable the check of the MTU value.C . Set the OSPF media type to point-to-point.D . Adjust the MTU...
Which action resolves the issue?
Refer to the exhibit. A network engineer upgrades the firmware of a Cisco Fabric Interconnect from boot flash. During the process, the fabric interconnect reboots and displays the message shown in the exhibit . Which action resolves the issue?A . Remove the service pack and upgrade through the auto-install procedureB...
Refer to the exhibit.
Refer to the exhibit. During implementation of a Cisco UCS C-Series Server, an engineer receives the status that is shown in the exhibit . Which action resolves the issue.A . Reconfigure the Drive Type from "Removable" to "Non-Removable"B . Insert an SD card into SLOT-2C . Configure the RAID that...
Which two actions resolve the issue?
An engineer must place a Cisco UCS B-Series Server in a single server pool in Cisco UCS Manager. The engineer creates a qualification policy, but the server is still seen in multiple pools . Which two actions resolve the issue? (Choose two.)A . Select the Server Pool Policy Qualification from...
Which action resolves the issue?
A server fails to boot from the operating system after a RAID1 cluster migration. The RAID remains in an inactive state during and after a service profile association . Which action resolves the issue?A . Configure the SAN boot target in the service profile.B . Configure the SAN boot target...
Which action should be taken to resolve the issue?
A system administrator connects a Cisco Nexus 2248PQ FEX to a fabric interconnect to expand the ports that are available for connecting Cisco UCS C-Series Rack Servers. In Cisco UCS Manager, the administrator does not see the servers connected to this FEX . Which action should be taken to resolve...
