- All Exams Instant Download
A Cisco engineer is preparing a service profile template for a design, which consists of 20 x UCS B200M6 blade servers 2 x UCS 6454 Fabric Interconnect in End Host Mode, and 3 x UCS 5108 server chassis with 2408 Fabric Extenders The blade servers are equipped with VIC 1480 adapters The engineer does not configure a vNIC/vHBA placement policy in the service profile and the vNICs and vHBAs are assigned to the vCon in a particular order What is the mapping scheme in which Cisco UCS assigns the vCons based on the type of server and the selected virtual slot?
A Cisco engineer is preparing a service profile template for a design, which consists of 20 x UCS B200M6 blade servers 2 x UCS 6454 Fabric Interconnect in End Host Mode, and 3 x UCS 5108 server chassis with 2408 Fabric Extenders The blade servers are equipped with VIC 1480...
Drag the appropriate from the left onto the current UDLD modes of operation on the right
DRAG DROP Drag the appropriate from the left onto the current UDLD modes of operation on the right. View AnswerAnswer:
Which port type should be used to meet these requirements?
An engineer must connect an existing Cisco Fabric Interconnect to an IP-based storage array. The connection be a channel made directly between the fabric interconnect expansion module and the storage array. The engineer must also consider that the environment is running FCoE for storage and uses QoS to prioritize traffic....
Drag and drop the configurations from the left onto the correct policies on the right
DRAG DROP Drag and drop the configurations from the left onto the correct policies on the right. View AnswerAnswer:
Which solution must the engineer use to meet the requirements?
Refer to the exhibit. An engineer is configuring a QoS policy with these requirements ✑ Match-all AF11 traffic and set it to a DSCP value of 14. ✑ The committed rate must be 10 Mbps with a committed burst rate of 1000 ms ✑ Drop any AF11 traffic that violates...
Which two configuration methods can be used to deploy QoS to Cisco MDS Series switches? (Choose two.)
Which two configuration methods can be used to deploy QoS to Cisco MDS Series switches? (Choose two.)A . zone-based QoS B. multiple QoS policies that match individual devices C. VSAN-based QoS D. FCoE VLAN-based QoS E. multiple QoS policies that match multiple devicesView AnswerAnswer: C E Explanation: VSAN-based QoS: QoS...
Which action successfully forms the domain?
Refer to the exhibit. In this scenario a Cisco engineer is building a loop-free topology where a dedicated layer of the vPC domain adjacent to the aggregation layer which also runs vPC Is used to interconnect the two data centers together. The engineer globally configures a vPC domain identifier on...
Which feature must be used to meet these requirement?
An engineer must use OTV for layer 2 connectivity between data centers to support virtual machine between the customer sites. To support this requirement, the engineer must ensure the existence of the same default gateway on both sites. Additionally, the operations team report high bandwidth utilization on site A and...
Which Cisco HyperFlex deployment model meets these requirements?
An engineer must deploy a Cisco HyperFlex system at two data centers. For redundancy reasons, the setup must achieve data protection in case of an entire site failure. The data must be available on both sites at all times to keep the recovery time objective to a minimum. Which Cisco...
Which solution meets these requirements?
A company data center requires a new disaster recovery solution to host critical services. The solution can sustain several hours of data loss because the services are routinely backed up to an offsite location. Also, the disaster recovery solution must provide 24-hour availability. Due to the strict policy requirements, the...
