- All Exams Instant Download
Which tasks should the engineer use to solve the routing issues?
DRAG DROP An engineer is troubleshooting end-to-end customer traffic across an MPLS VPN service provider network. Which tasks should the engineer use to solve the routing issues? Drag and drop the table types from the left onto the most useful troubleshooting tasks/router types on the right. (Not all options are...
Where should the soft preemption be applied to solve the issue?
Refer to the exhibit. A network operator is troubleshooting TE tunnels and discovers that the soft preemption is not working as desired. Where should the soft preemption be applied to solve the issue?A . on the tail-end device for tunnel-te1 192.168.0.7B . under the tunnel-te1 interface on PE1C . explicitly...
What is the characteristic of enabling segment routing for IGPs?
What is the characteristic of enabling segment routing for IGPs?A . Segment routing must first be enabled under the routing process and then globally.B . Segment routing must first be enabled globally and then under the routing process.C . Segment routing must be enabled only globally.D . Segment routing must...
After troubleshooting BGP traffic steering issue, which action did the network operator take to achieve the correct effect of this configuration?
Refer to the exhibit. After troubleshooting BGP traffic steering issue, which action did the network operator take to achieve the correct effect of this configuration?A . Routes that have passed through AS 65517 have the local preference set to 150.B . Routes that have originated through AS 65517 have the...
What are three requirements for a static IPv6-in-IPv4 tunnel? (Choose three.)
What are three requirements for a static IPv6-in-IPv4 tunnel? (Choose three.)A . A static IPv6 address must be configured.B . A dynamic IPv6 address must be configured.C . Cisco Express Forwarding must be enabled.D . Each tunnel endpoint must support IPv4 and IPv6.E . A static IPv4 address must be...
Which output from the show isis interface command helps an engineer troubleshoot an IS-IS adjacency problem on a Cisco IOS-XR platform?
Which output from the show isis interface command helps an engineer troubleshoot an IS-IS adjacency problem on a Cisco IOS-XR platform?A . metricB . priorityC . circuit typeD . hello intervalView AnswerAnswer: D
Which two actions fix the issue?
Refer to the exhibit. P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied. The BGP session is not coming up. Assume that there is no IP reachability problem and both routers can open tcp port 179 to each other. Which two actions fix the...
Which interface and label path should the operator investigate next?
Refer to the exhibits. A network operator is troubleshooting packet loss seen from the R1 loopback interface to the R2 loopback interface over the core network. The operator is attempting to identify the next leg in the path from PE1. Which interface and label path should the operator investigate next?A...
What are two differences between OSPF and IS-IS? (Choose two.)
What are two differences between OSPF and IS-IS? (Choose two.)A . OSPF is a link-state routing protocol, and IS-IS is a distance-vector routing protocol.B . OSPF uses a router ID to identify a router, and IS-IS uses a system ID . OSPF elects a DR and a BDR, and IS-IS...
Which element needs to be implemented to make this feature function effectively?
Refer to the exhibit. A network operators configuring BGP PIC on CE1 on already established neighborships with PE1ana PE2 inside the fully converged MPLS network. Which element needs to be implemented to make this feature function effectively?A . Bidirectional Forwarding Detection must be applied to the upstream facing BGP interfaces.B...
