- All Exams Instant Download
Which additional configuration must an engineer apply to router R1 so it filters all MSDP SA messages from Domain-C?
Refer to the exhibit Router R1 is configured to advertise outgoing SA messages to routers R2 and R3, but to receive incoming SA messages only from R2 . Which additional configuration must an engineer apply to router R1 so it filters all MSDP SA messages from Domain-C?A . R1# ip...
Which statement about this configuration is true?
Refer to the exhibit. Which statement about this configuration is true?A . Router 1 sends and receives multiple best paths from neighbor 192.168.1.1B . Router 1 sends up to two paths to neighbor 192.168.1.1 for all routesC . Router 1 receives up to two paths from neighbor 192.168.1.1 for all...
Where should the soft preemption be applied to solve the issue?
Refer to the exhibit. A network operator is troubleshooting TE tunnels and discovers that the soft preemption is not working as desired. Where should the soft preemption be applied to solve the issue?A . on the tail-end device for tunnel-te1 192.168.0.7B . under the tunnel-te1 interface on PE1C . explicitly...
What is the next hop for node A on its way to node D, with the objective of achieving a low delay?
Refer to the exhibit. The green policy is designed with low delay, and the pink policy is designed with low cost . What is the next hop for node A on its way to node D, with the objective of achieving a low delay?A . 192.168.3.2B . 192.168.1.6C . 192.168.3.6D...
Which command is used to enable BIDIR-PIM under global configuration mode for Cisco IOS XE Sofware?
Which command is used to enable BIDIR-PIM under global configuration mode for Cisco IOS XE Sofware?A . ip pim bidir-enableB . ipv4 pim bidir-enableC . ip multicast-routingD . ip pim bidirView AnswerAnswer: A Explanation: Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipmulti_pim/configuration/xe-3s/imc-pim-xe-3sbook/imc_basic_cfg.html
What action must the engineer take to solve this issue?
An engineer is troubleshooting slow performance issues on a customer’s network after the last multicast configuration change was applied on it While checking the running configuration on the router the engineer notices there are many ip igmp join-group commands applied on several interfaces of the router which caused the high...
Which command can the operator use to enforce R2 to have a strict prefix-sid assignment to loopback0?
Refer to the exhibit. A network operator wants to expand the segment routing global block in upcoming maintenance. The operator must ensure that the changes to the segment routing global block have no adverse impacts on the prefix-sid associated with the loopback0 interface used within the OSPF domain. Which command...
Which expression, when used with the as-path-set command, matches the AS path attribute of the route?
Which expression, when used with the as-path-set command, matches the AS path attribute of the route?A . neighbor-isB . dfa-regtexC . ios-regexD . LengthView AnswerAnswer: C
Which cost is the default when redistributing routes from BGP to OSPF?
Which cost is the default when redistributing routes from BGP to OSPF?A . 20B . 1C . infiniteD . automaticView AnswerAnswer: B Explanation: Reference: http://www.ciscopress.com/articles/article.asp?p=27573
How should the engineer solve the issue?
Refer to the exhibit. While configuring router 2 with all the default values, a network engineer cannot see any route received in router 1. How should the engineer solve the issue?A . Set up a priority different than 0 in the interface.B . Modify the router ID to be the...
