- All Exams Instant Download
Drag and drop the features about multicast from the left onto the multicast protocols on the right. Not all options ate used
DRAG DROP Drag and drop the features about multicast from the left onto the multicast protocols on the right. Not all options ate used. View AnswerAnswer:
What are three requirements for a static IPv6-in-IPv4 tunnel? (Choose three.)
What are three requirements for a static IPv6-in-IPv4 tunnel? (Choose three.)A . A static IPv6 address must be configured. B. A dynamic IPv6 address must be configured. C. Cisco Express Forwarding must be enabled. D. Each tunnel endpoint must support IPv4 and IPv6. E. A static IPv4 address must be...
What is the difference between a source tree and a shared tree in a multicast environment?
What is the difference between a source tree and a shared tree in a multicast environment?A . To route traffic from source to receiver a source tree uses a link-state routing protocol and a shared tree uses a distance-vector routing protocol. B. A source tree has its root at the...
How should the engineer solve the issue?
Refer to the exhibit. While configuring router 2 with all the default values, a network engineer cannot see any route received in router 1 . How should the engineer solve the issue?A . Set up a priority different than 0 in the interface. B. Modify the router ID to be...
Which expression, when used with the as-path-set command, matches the AS path attribute of the route?
Which expression, when used with the as-path-set command, matches the AS path attribute of the route?A . neighbor-is B. dfa-regtex C. ios-regex D. LengthView AnswerAnswer: C
Which action resolves the issue?
Refer to the exhibit. Company A established BGP sessions with several ISPs. A network engineer at the company must filter out all traffic except for routes that transit AS 152. The engineer configured the filtering policy “permit _152S_(_[0.9])” on R1, but after applying the configuration, the engineer notices that other...
Which command is used to enable BIDIR-PIM under global configuration mode for Cisco IOS XE Software?
Which command is used to enable BIDIR-PIM under global configuration mode for Cisco IOS XE Software?A . ip pim bidir ip B. multicast-routing C. ipv4 pim bidir-enable D. Ip pim bidlr-enableView AnswerAnswer: D
Which two actions fix the issue?
Refer to the exhibit. P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied. The BGP session is not coming up. Assume that there is no IP reachability problem and both routers can open tcp port 179 to each other . Which two actions fix...
Which configuration must be applied to router R2 to correct the problem?
Refer to the exhibit. There is a connectivity issue between Customer-1 and Customer-2 File servers between the customers cannot send critical data R3 routes are missing from the routing table on the Customer-1 router All interlaces on Customer-1 are up. Which configuration must be applied to router R2 to correct...
Which action makes the peering come back up again?
After an engineer configures BGP in R1, it starts receiving this message *Jun 29 13:30:50.122: %BGP-5-ADJCHANGE: neighbor 192.168.10.1 Down User reset Jun 29 13:30:52.341: %BGP-3-NOTIFICATION: sent to neighbor 192.168.10.1 2/6 (unacceptable hold time) 0 bytes Which action makes the peering come back up again?A . Make a soft reset to...
