- All Exams Instant Download
What is observed in the output on PI?
Refer to the exhibit. An engineer needs to manage non-802.11 interference. What is observed in the output on PI?A . At least one strong interferer is impacting connectivity at this site. B. Several light interferers are collectively impacting connectivity at this site. C. The three individual clusters shown indicate poor...
Which two Layer 2 security options are supported in this environment?
An engineer must configure a Cisco WLC to support Cisco Aironet 600 Series OfficeExtend APs. Which two Layer 2 security options are supported in this environment? (Choose two.)A . Static WEP + 802.1X B. WPA+WPA2 C. Static WEP D. CKIP E. 802.1XView AnswerAnswer: BC
Which configuration should be used to accomplish this goal?
A corporation is spread across different countries and uses MPLS to connect the offices. The senior management wants to utilize the wireless network for all the employees. To ensure strong connectivity and minimize delays, an engineer needs to control the amount of traffic that is traversing between the APs and...
Which protocol must be allowed to reach the MSE from the controllers?
A new MSE with wIPS service has been installed and no alarm information appears to be reaching the MSE from controllers. Which protocol must be allowed to reach the MSE from the controllers?A . SOAP/XML B. NMSP C. CAPWAP D. SNMPView AnswerAnswer: A
What is the difference between PIM sparse mode and PIM dense mode?
What is the difference between PIM sparse mode and PIM dense mode?A . Sparse mode supports only one switch. Dense mode supports multiswitch networks. B. Sparse mode floods. Dense mode uses distribution trees. C. Sparse mode uses distribution trees. Dense mode floods. D. Sparse mode supports multiswitch networks. Dense mode...
Which configuration allows the devices to communicate over NMSP?
A network engineer has been hired to perform a new MSE implementation on an existing network. The MSE must be installed in a different network than the Cisco WLC. Which configuration allows the devices to communicate over NMSP?A . Allow UDP/16113 port on the central switch. B. Allow TCP/16113 port...
Which Cisco vMSE Release 8 option must the engineer deploy?
An engineer configures a deployment to support: ✑ Cisco CMX ✑ licenses for at least 3000 APs ✑ 6000 wIPS licenses The Cisco vMSE appliance must be sized for this deployment. Which Cisco vMSE Release 8 option must the engineer deploy?A . Large vMSE B. Low-End vMSE C. Standard vMSE...
Which configuration is needed to complete this task?
An engineer wants to configure WebEx to adjust the precedence and override the QoS profile on the WLAN. Which configuration is needed to complete this task?A . Change the WLAN reserved bandwidth for WebEx B. Create an AVC profile for WebEx C. Create an ACL for WebEx D. Change the...
When using a Cisco Catalyst 9800 Series Wireless Controller, which statement about AutoQoS is true?
When using a Cisco Catalyst 9800 Series Wireless Controller, which statement about AutoQoS is true?A . It has a set of predefined profiles that you cannot modify further B. It matches traffic and assigns each matched packet to QoS groups C. It automates deployment of wired QoS and makes wireless...
When configuring a Cisco WLC, which CLI command adds a VLAN with VLAN ID of 30 to a FlexConnect group named BranchA-FCG?
When configuring a Cisco WLC, which CLI command adds a VLAN with VLAN ID of 30 to a FlexConnect group named BranchA-FCG?A . config flexconnect BranchA-FCG vlan 30 add B. config flexconnect BranchA-FCG vlan add 30 C. config flexconnect group BranchA-FCG vlan 30 add D. config flexconnect group BranchA-FCG vlan...
