- All Exams Instant Download
Which architecture should the engineer deploy?
An engineer Is trying to determine the most cost-effective way to deploy high availability for a campus enterprise wireless network that currently leverages three wireless LAN controllers . Which architecture should the engineer deploy?A . N+1 solution without SS0B . N+1 with SSOC . N+N solution without SSOD . N+N...
Which approach should be taken?
A network engineer is designing a new wireless network. The network needs to have these characteristics: Which approach should be taken?A . Deploy APs near each other for 5 GHz coverage, and disable the 2A GHz radios for some Aps.B . Deploy APs near each other for 2.4 GHz coverage,...
Which configuration is the cause of this issue?
A company has 10 access point licenses available on their backup Cisco WLC and their primary Cisco WLC is at full capacity, 5 access points are set to high failover priority and 7 access points are set to critical failover priority. During a failure, not all critical access points failed...
Which Cisco WLC configuration setting must be incorporated in the design to encourage clients to use the 5 GHz spectrum?
A high-density wireless network is designed . Which Cisco WLC configuration setting must be incorporated in the design to encourage clients to use the 5 GHz spectrum?A . RRMB . Cisco centralized key managementC . Band selectD . Load balancingView AnswerAnswer: C
Which reason explains this behavior?
A technician connects a Cisco Aironet 3700 Series access point to a switch and realizes that the AP is coming up with 3x3 MIMO . Which reason explains this behavior?A . A redundant power supply is unavailable on the switch.B . The switch is 802.3af capable.C . The AP is...
An engineer is designing a wireless network that will support many different types of wireless clients. When conducting the survey, which client must be used to ensure a consistent experience for all of the wireless clients?
An engineer is designing a wireless network that will support many different types of wireless clients. When conducting the survey, which client must be used to ensure a consistent experience for all of the wireless clients?A . the client that has the highest RF propertiesB . the client that is...
Which type of wireless architecture should be used?
An engineer is designing a network deployment for a college with six buildings Each building must have a WLC located in the IDF to support the APs. The wireless clients should be able to roam between the APs and the controllers . Which type of wireless architecture should be used?A...
Which operating mode is configured for a Cisco Clean AIR AP?
An engineer performs a Layer 1 survey by using Metegeek chanalyzer only on the current operating channel . Which operating mode is configured for a Cisco Clean AIR AP?A . LocalB . SnifferC . MonitorD . SE-connectView AnswerAnswer: A
Which scenario explains the client roaming behavior?
Refer to the exhibit. A client roams between two APs that are registered to two different controllers, where each controller has an interface in the client subnet. Both controllers are running AireOS . Which scenario explains the client roaming behavior?A . Controllers exchange mobility control messages (over UDP port 16666)...
Which traffic flow must be allowed at the firewall to enable the communication?
An engineer has configured guest anchoring for a newly created SSD however, the mobility tunnels are not up, and EPING is failing from the foreign WLC to the anchor WLC . Which traffic flow must be allowed at the firewall to enable the communication?A . UDP port 16666B . IP...
