- All Exams Instant Download
Which mechanism should be included to avoid routing loops?
Refer to the exhibit. An architect must design a solution to connect the network behind R3 with the EIGRP network. Which mechanism should be included to avoid routing loops?A . split-horizon B. summarization C. down bit D. route tagsView AnswerAnswer: D
Which type of transport encryption must be used in this environment?
A company's security policy requires that all connections between sites be encrypted in a manner that does not require maintenance of permanent tunnels. The sites are connected through a private MPLS-based service that uses a dynamically changing key and spoke-to-spoke communication. Which type of transport encryption must be used in...
Which solution should the engineer include to prevent potential issues with choppy voice traffic?
An engineer must design a solution to connect a customer to the Internet. The solution will include a Layer 3 circuit with a CIR of 50 Mbps from the service provider. The hand-off from the provider's switch to the customer's router is 1Gbps. Which solution should the engineer include to...
Which route filtering solution must the engineer employ?
An engineer must peer with an ISP for internet connectivity using BGP, initially, the engineer wants to receive only specific prefixes from the ISP and a default route. However, the solution must provide the flexibility to add prefixes in the future at short notice. The ISP has a two-week change...
Which two steps can be taken to improve convergence in an OSPF network? (Choose two.)
Which two steps can be taken to improve convergence in an OSPF network? (Choose two.)A . Use Bidirectional Forwarding Detection B. Merge all the areas into one backbone area C. Tune OSPF parameters D. Make all non-backbone areas stub areas E. Span the same IP network across multiple areas.View AnswerAnswer:...
Drag and drop the properties from the left onto the Cisco SD-WAN components that perform them on the right
DRAG DROP Drag and drop the properties from the left onto the Cisco SD-WAN components that perform them on the right. View AnswerAnswer: Explanation: Graphical user interface, application Description automatically generated
Which type of rendezvous point deployment is standards-based and supports dynamic RP discovery?
Which type of rendezvous point deployment is standards-based and supports dynamic RP discovery?A . bootstrap router B. Anycast-RP C. Auto-RP D. static RPView AnswerAnswer: A
Which two overlay network design considerations must be made for a Cisco SD-Access network? (Choose two.)
Which two overlay network design considerations must be made for a Cisco SD-Access network? (Choose two.)A . LAN automation for deployment B. Layer 3 to the access design C. Reduce subnets and simplify DHCP management D. Dedicated IGP process for the fabric E. Avoid overlapping IP subnetsView AnswerAnswer: C,E Explanation:...
Which area type does the engineer choose to provide minimal router resources utilization, while still allowing for full connectivity to the rest of the network?
An engineer must connect a new remote site to an existing OSPF network. The new site consists of two low-end routers, one for WAN, and one for LAN. There is no demand for traffic to pass through this area. Which area type does the engineer choose to provide minimal router...
Which two best practices must be followed when designing an out-of-band management network? (Choose two.)
Which two best practices must be followed when designing an out-of-band management network? (Choose two.)A . Enforce access control B. Facilitate network integration C. Back up data using the management network D. Ensure that the management network is a backup to the data network E. Ensure network isolationView AnswerAnswer: A,E...
