- All Exams Instant Download
Which action must the engineer take to resolve the issue?
Refer to the exhibits. An engineer filtered messages based on severity to minimize log messages. After applying the filter, the engineer noticed that it filtered required messages as well. Which action must the engineer take to resolve the issue?A . Configure syslog level 2B . Configure syslog level 3C ....
What must be configured on the router to mount it in the Cisco DNA Center?
Refer to the exhibit. A network administrator added one router in the Cisco DNA Center and checked its discovery and health from the Network Health Dashboard. The network administrator observed that the router is still showing up as unmonitored. What must be configured on the router to mount it in...
What should be configured to resolve the issue?
Refer to the exhibit. The administrator successfully logs into R1 but cannot access privileged mode commands. What should be configured to resolve the issue?A . aaa authorization reverse-accessB . secret cisco123! at the end of the username command instead of password cisco123!C . matching password on vty lines as cisco123!D...
What is the minimum time gap required by the local system before putting a BFD control packet on the wire?
What is the minimum time gap required by the local system before putting a BFD control packet on the wire?A . Required Min RX IntervalB . Required Min Echo RX IntervalC . Detect MultD . Desired Min TX IntervalView AnswerAnswer: D
Which two configurations allow clients to get dynamic ip addresses assigned?
Refer to exhibit. Which two configurations allow clients to get dynamic ip addresses assigned? (Choose two)A . Configure access-list 100 permit udp any any eq 68 as the first lineB . Configure access-list 100 permit udp any any eq 86 as the first lineC . Configure access-list 100 permit udp...
Which action resolves the issue?
Refer to the exhibit. The OSPF routing protocol is redistributed into the BGP routing protocol, but not all the OSPF routes are distributed into BGP. Which action resolves the issue?A . Use a route-map command to redistribute OSPF external routes defined in a prefix list.B . Use a route-map command...
Which tool must be used to diagnose the issue using Cisco DNA Center Assurance?
A customer reports to the support desk that they cannot print from their PC to the local printer id:401987778. Which tool must be used to diagnose the issue using Cisco DNA Center Assurance?A . application traceB . path traceC . ACL traceD . device traceView AnswerAnswer: B
What are two functions of MPLS Layer 3 VPNs? (Choose two)
What are two functions of MPLS Layer 3 VPNs? (Choose two)A . BGP is used for signaling customer VPNv4 routes between PE nodes.B . It is used for transparent point-to-multipoint connectivity between Ethernet links/sites.C . LDP and BGP can be used for Pseudowire signaling.D . A packet with node segment...
Which command is required on the Fastethernet0/0 interface of RouterB to resolve this issue?
Refer to the exhibit. The DHCP client is unable to receive an IP address from the DHCP server. RouterB is configured as follows: Which command is required on the Fastethernet0/0 interface of RouterB to resolve this issue?A . RouterB(config-if)#ip helper-address 172.31.1.1B . RouterB(config-if)#ip helper-address 172.16.1.2C . RouterB(config-if)#ip helper-address 172.16.1.1D ....
Which set of configurations resolves the issue?
Refer to the exhibit. An engineer has successfully set up a floating static route from the BRANCH router to the HQ network using HQ_R1 as the primary default gateway. When the g0/0 goes down on HQ_R1, the branch network cannot reach the HQ network 192.168.20.0/24. Which set of configurations resolves...
