300-410 exam

An engineer is trying to copy an IOS file from one router to another router by using TFTP. Which two actions are needed to allow the file to copy? (Choose two.)A . Copy the file to the destination router with the copy tftp: flash: commandB . Enable the TFTP server...

DRAG DROP Drag and drop the operations from the left onto the locations where the operations are performed on the right. View AnswerAnswer: Explanation: Label Switch Router

Refer to the exhibit. An engineer is troubleshooting BGP on a device but discovers that the clock on the device does not correspond to the time stamp of the log entries. Which action ensures consistency between the two times?A . Configure the service timestamps log uptime command in global configuration...

Refer to the exhibits. Phase-3 tunnels cannot be established between spoke-to-spoke in DMVPN. Which two commands are missing? (Choose two.)A . The ip nhrp redirect command is missing on the spoke routers.B . The ip nhrp shortcut command is missing on the spoke routers.C . The ip nhrp redirect commands...

Refer to the exhibit. An engineer is trying to get 192.168.32.100 forwarded through 10.1.1.1, but it was forwarded through 10.1.1.2 . What action forwards the packets through 10.1.1.1?A . Configure EIGRP to receive 192.168.32.0 route with lower admin distance.B . Configure EIGRP to receive 192.168.32.0 route with longer prefix than...

R2 has a locally originated prefix 192.168.130.0/24 and has these configurations: What is the result when the route-map OUT command is applied toward an eBGP neighbor R1 (1.1.1.1) by using the neighbor 1.1.1.1 route-map OUT out command?A . R1 sees 192.168.130.0/24 as two AS hops away instead of one AS...

Refer to the exhibit. A company is evaluating multiple network management system tools. Trending graphs generated by SNMP data are returned by the NMS and appear to have multiple gaps. While troubleshooting the issue, an engineer noticed the relevant output. What solves the gaps in the graphs?A . Remove the...

DRAG DROP Drag and drop the addresses from the left onto the correct IPv6 filter purposes on the right. View AnswerAnswer: Explanation: HTTP and HTTPs run on TCP port 80 and 443, respectively and we have to remember them. Syslog runs on UDP port 514 while NTP runs on UDP...

Which statement about MPLS LDP router ID is true?A . If not configured, the operational physical interface is chosen as the router ID even if a loopback is configured.B . The loopback with the highest IP address is selected as the router ID . The MPLS LDP router ID must...